770037
23
Zoom out
Zoom in
Previous page
1/110
Next page
22
Please note: You should customise water hardness as soon as possible following the
instructions in section “7. Menu settings”.
3. SETTING UP THE APPLIANCE
1. Plug the power cord connector (C7) into the socket (A16) at
the back of the appliance (g. 4); then plug the plug into
the mains socket. Make sure the main switch (A17), at the
back of the appliance is pressed and in the I position (g.
5);
2. Place a container with a minimum capacity of 100 ml under
the hot water spout (A7)) and cappuccino maker (g. 6);
3. Press the button (B7) corresponding to the light (g.
7). Delivery begins and stops automatically. Empty the
container.
Before using the machine, you must rinse the internal circuits.
Proceed as follows:
4. Attach the lter holder (C1) complete with lter to the appli-
ance. To attach correctly, align the lter holder handle with
“INSERT” (g. 8), then turn the handle to the right until it is
aligned in the “CLOSE” position;
5. Place a recipient under the lter holder and cappuccino
maker (A5);
6. Press the button (B5) corresponding to the light. De-
livery begins (g. 9);
7. When delivery is complete, turn the steam dial (A4) (g.
10) and deliver steam for a few seconds to rinse the steam
circuit; or optimal steam performance we recommend you
repeat this action 3 or 4 times. This is to purge the steam
arm before frothing or steaming your milk.
.
The appliance is ready for use.
Please note: We also recommend rinsing the internal circuits if the appliance is
not used for a long period.
The rst time you use the appliance, you need to make 4-5 cups
of coee before the appliance starts to give satisfactory results.
Pay particular attention to the quantity of pre-ground coee in
the lter ((C2) or (C3)) (see instructions in section “4.1 Step 1 -
grinding (g. 11)”).
Proceed as described in section “The „perfect dose“.
4. COFFEE DELIVERY
4.1 Step 1 - grinding (g. 11)
1. Add beans to hopper (A1) (g. 12). Fresh is best; ll in just
with the quantity you need.
2. Select the ness (g. 13). The factory setting is 5 (medium
grinding). if you are not satised, adjust the level according
to your personal taste and the type of coee (do it while
grinding).
3. Select single (C2) or double dose lter (C3) and place in the
portalter (C1) (g. 14). If you are using the double lter,
press the X2 button (B3): this will double the volume of the
espresso shot as well.
4. Set the dose level by adjusting the dial (B2) starting from
the min. position. (g. 15).
Please note:
The numbers displayed on the indica-
tor (B19) are a setting reference once
the right level of coee in the portal-
ter is reached. They do not correspond
to grinder settings or to measurement
units (gr/oz) or to grinding time.
Refer to “The „perfect dose““ for
suggestions.
5. Attach portalter to the coee mill outlet (A18) aligning
it with “INSERT”: then turn the portalter to the right (g.
16). Grinding begins when the lter holder reaches the
CLOSE position and stops automatically.
4.2 Adjust dose
Extra grinding
adjustment
XLIGHT
LIGHT
MEDIUM
MEDIUM  DARK
DARK
XDARK
Each variety of coee beans can behave dierently during grind-
ing and this is the reason why setting the dose at the beginning
might require extra care.
With this illustration we give you some indications on how to
regulate the dose. Please note these suggested setting ranges,
based on the roasting level, are certainly a good starting point,
but they might slightly vary depending on specic composition
of your coee beans.
1. Set the dose starting from the minimum position.
2. Look at which roasting level your coee is and based on
that, turn the knob slowly, referencing the ranges.
4.3 Step 2 - tamping (g. 17)
1. After grinding, pull the lever (A20) down fully (do not re-
move portalter) (g. 18). For a perfect result, you can do
it twice.
2. Keep the lever down while removing the portalter (g.
19). Once it is done, place back the lever in its original
position.
3. Check the dose (see “The „perfect dose““) and attach the
portalter to the brewing unit
(A7) (g. 20).
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi EC9665 La Specialista Maestro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi EC9665 La Specialista Maestro in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 40.95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info