770085
13
Zoom out
Zoom in
Previous page
1/88
Next page
13
7. ALARMS SHOWN ON DISPLAY
ALARM CAUSE SOLUTION
Tank (A6) missing or incorrectly
positioned
Place the tank back in its correct position (see para-
graph “3.1 Draining into the tank”)
Tank full Empty the tank (see paragraph “3.1 Draining into the
tank”)
Room temperature too low (see op-
erating limits in chap. “6. Technical
Specications”)
Increase the room temperature if possible
Humidity in room too low or too high for
correct measuring (see operating limits
in chap. “6. Technical Specications”)
Move the appliance to another room with humidity
and temperature levels within the operating limits: if
the problem persists, call the Service Centre.
Faulty probe Call Service Centre
Wi-Fi interface not working properly Turn the appliance o and disconnect the plug from
the power socket. Wait a few minutes, then re-insert
the plug: if the problem persists, contact the Service
Centre.
After a preset number of operating hours,
the symbol (C2) blinks on the display
to indicate that the HEPA-type (E12)*
lter (A7) needs to be replaced.
Replace the HEPA-type (E12)* lter (see para. “5.3
Replacing the HEPA-type (E12)* lter”).
If the HEPA-type (E12)* lter has recently been re-
placed, reset the alarm (see para.“5.3 Replacing the
HEPA-type (E12)* lter”)
8. TROUBLESHOOTING
Below is a list of possible malfunctions.
If the problem cannot be resolved using the proposed solution,
contact the Service Centre.
PROBLEM CAUSE SOLUTION
The appliance is operating in dehumid-
ifying mode, but the humidity does not
decrease
The lter is clogged Clean the dust lter (para. “5.2 Cleaning
the dust lter”) and check whether the
HEPA-type (E12)* lter needs replacing
(see paragrah. “5.3).
Either the temperature or humidity in the
room is too low
In certain conditions the appliance will
not dehumidify: check the operating lim-
its of the appliance (see chap. “6. Techni-
cal Specications”). In certain cases, it is
recommended to heat the room needing
to be dehumidied.
The set relative humidity level is too high Set a lower humidity value (see para-
graph “4.1 Dehumidifying mode”).
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi DDSX 220WFA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi DDSX 220WFA in the language / languages: All languages as an attachment in your email.

The manual is 35.55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info