585987
12
Zoom out
Zoom in
Previous page
1/20
Next page
Installation Manual Rhino™ 10
Mount the Computer to the Vehicle
Hold the computer by the junction of the Ram mount arm and the base on the back of the unit. Lift the assembly to the
base on the vehicle. Open the arm until the end slides over the ball on that base. Tighten the wing nut firmly.
Once the computer is attached, it can adjusted by holding the bottom of the computer, loosening the wing nut on the
arm by one turn moving the Rhino™ 10 to the desired position and re-tightening the wing nut on the arm.
ALWAYS hold the Rhino™ 10 before loosening the arm. Failure to hold the Rhino™ 10 can cause it to
swing down suddenly and may cause injury or damage the unit!
Mounting the Keyboard
The Keyboard Mounting Kit includes:
2 interchangeable side supports
2 interchangeable mounting plates
12 8-32 machine screws with lock washers
Tools required:
#2 Phillips screwdriver (not included)
Prior to beginning this procedure you should have al-
ready attached the mounting base and mounting ball to
the computer as described in Adding Mounting Base to
Computer above.
1. Attach the long end of the two side supports to
the mounting base on the Rhino™ 10 using four
of the 8-32 screws and lock washers.
2. Attach the second flanged plate to the short end
of the sides with the flanges down using the four
8-32 screws and lock washers. Note that the
screw holes in the center of the mounting plate
are closer to one side of the mounting plate.
These holes should be place closest to the com-
puter so that, when the keyboard is attached, it
will be fully supported by the mounting plate. This
is shown in the picture to the left.
Side supports (2)
Mounting pl
ates (2)
8
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Datalogic Rhino 10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Datalogic Rhino 10 in the language / languages: English as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Datalogic Rhino 10

Datalogic Rhino 10 User Manual - English - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info