534695

Cubify CubeX Manual

15
Zoom out
Zoom in
Previous page
1/37
Next page
14
INSTALLING MATERIAL CARTRIDGE
NOTE: The REPLACE functions will take you through the process of installing the material cartridge.
1. Press REPLACE on the touchscreen and select the bay that the cartridge will be
installed. Print Jet 1 represents bay 1, Print Jet 2 represents bay 2 and Print Jet 3
represents bay 3. Press “Next” on the touchscreen, a message “Heating Print Jet
Please Wait…” will appear on the control panel. (Fig. 31)
CHECKING THE Z-GAP BETWEEN THE PRINT JET TIP AND THE PRINT PAD
CAUTION: Do not overdrive the print jet tip into the print pad. Doing so can cause damage to the print jet.
NOTE: If more than one print jet is equipped on your CubeX, use the rst print jet to set the gap.
1. Scroll to “Z GAP” using the arrows on the touchscreen. Select
Z GAP and using the “Up / Down” arrows, move the print pad
up so that it is just touching the tip of the print jet. (Fig. 28 &
29)
!
Fig. 28
Fig. 29
Fig. 30
Fig. 32
Fig. 31
Fig. 33
Fig. 34
1
3
2
2. Using the “Down” arrow, lower the printpad down by 0.1 from the print jet tip.
Click on the Control button, the next screen will allow you to save the setting.
Click on the check mark to save or the X to cancel the setting. (Fig. 30)
2. If the top cover is on, remove cover from the CubeX by lifting up. (Fig. 32)
3. Remove the thumbscrew from the new cartridge and retain thumbscrew to use when
storing the used cartridge that has material inside. This will prevent the material from
unraveling when stored. (Fig. 33)
4. Pull 300mm (11”) of material from the new cartridge.
5. Cut 50mm (1.5”) from the end of the lament. (Fig. 34)
Z GAP
Z
SET Z HEIGHT
Offset:-19.82
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cubify CubeX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cubify CubeX in the language / languages: English as an attachment in your email.

The manual is 4,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info