736211

Crivit IAN 304198 Manual

20
Zoom out
Zoom in
Previous page
1/76
Next page
24
Resetting the display
The display is on 0 only when used for the first
time. With all subsequent training sessions, the
computer continues counting from the last time
you trained. To reset the display, keep the MODE
button pressed down until all symbols can be seen
at the same time.
To reset the total number of training steps (TTR),
remove the battery.
Training instructions
General
Consult with your doctor before you start training!
Goal-setting
Various goals can be achieved through
appropriate training:
• Improvement in your general fitness levels
• Increase in endurance
• Improved feeling of well-being
Success is essentially dependent on the following
points, which we would particularly like to bring to
your attention:
• Regular training and sufficient duration of
training sessions
• Appropriate nutrition
• Monitoring your training milestones
Who can train?
If you haven’t trained or participated in sport
for an extended period, have cardiovascular or
orthopaedic problems, take medication, or are
pregnant, you should consult your doctor before
you commence training. Tell him/her which
training equipment you intend using. Undergo
an examination to ascertain which training
programmes are suitable for you. To be safe, take
the operating instructions with you, so that your
doctor may put together an individual training
programme with you.
In general, every physically healthy person,
whether young or old, can begin a fitness training
programme, if he/she has consulted a doctor
beforehand.
Note!
Incorrect or excessive training can
endanger your health.
Display
The top row displays:
1. “STOP”, if training is paused;
2. The number of steps per minute (projection)
Selecting the mode
The 4 modes are displayed on the bottom row.
Briefly press the MODE button to change from one
mode to the next.
1. “TMR”: Training time to date, from 0:00 to
99:59
2. “REPS”: Number of steps completed during the
current training session from 0 to 9999
3. “CAL”: Calories burned* from 0 to 9999
4. “TTR”: Number of training steps since inserting
the battery, from 0 to 9999
* The calculation is based on pre-programmed
standard values, that serve as a guideline only.
The calories burned through use of the straps is not
considered.
You may display all the training data, one after the
other. To do this, press the “MODE” button a few
times, until the “TMR” row blinks. The display will
then automatically change from mode to mode
every 5 seconds.
Entering training goals
You may enter one or more goals:
- Duration of training (TMR)
- Number of steps (REPS)
- Calorie consumption (CAL)
1. Hold the MODE button down until “0:00
(TMR)” appears in the bottom row and the first 0
blinks (approx. 7 secs.).
2. To enter your training duration, press the MODE
button several times, until the display shows the
required duration in minutes.
3. After a few seconds the display will show the
next mode (REPS). Press the MODE button, to set
the amount of steps in increments of 10.
4. You may set the desired calorie consumption in
the next mode (CAL) in increments of 10.
5. Now you may start with your training. The com-
puter counts down the pre-programmed values
to “0:00”.
6. As soon as the pre-programmed goal is reached,
the computer ceases to count for approx. 10
seconds. Afterwards, the computer starts again
at 0.
GB/IE
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit IAN 304198 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit IAN 304198 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 2,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info