768916
6
Zoom out
Zoom in
Previous page
1/31
Next page
18 - adjusting the recline position
The pushchair seat can be adjusted to 3 different positions of recline. Press the buttons (a) located
on both sides of the pushchair seat simultaneously and move to the desired position (b & c) until a
positive click is heard.
WARNING: Never adjust the seat unit with your child in the seat.
19 - Fitting, lifting and removing the bumper bar
Fit the bumper bar by pushing each end into the seat unit mountings until the buttons lock in place (a).
To open the bumper bar press the button on one side of the mounting (b) and lift the bumper bar
clear (c). Repeat this procedure at the other end of the bumper bar to remove the bar from the seat.
The bumper bar cover can be detached from the bumper bar by unzipping the cover at the back (d).
20 - using the harness
A five point harness is provided to restrain your child. To unfasten push the button on the buckle
(a) and pull the clips clear.
To fasten the harness push the shoulder strap clips onto the waist strap clips (b) then push the
waist strap clips into the buckle until they lock in place (c).
Sliding adjusters are fitted on the shoulder straps, waist straps and crotch strap (d). The harness
should be carefully adjusted so that it fits your child comfortably. To adjust to the smallest size on
the waist strap you will need to thread the adjusters through the “D” ring.
To adjust the shoulder strap height, unzip the liner on the back of the seat, locate the strap ends
(e) and pass through the slots, reposition to the desired height and pass the strap ends back
through relevant slot.
To remove the harness unzip the liner on the back of the seat, locate the strap ends (e) and
pass through the slots. Under the seat, pass the crotch strap end through its slot (f). On each side
of the seat feed the edge of the webbing through the opening in the ‘C’ clip (g). Push the ‘C’ clip
through the ‘D’ clip. The harness can now be removed from the seat.
Refitting the harness is a reversal of this procedure.
‘D’ rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
To remove or fit the chest pads unclip the buckle and remove the shoulder strap clips from the
waist strap clips and slide the chest pads on or off the straps.
WARNING: Always use the crotch strap in combination with the
waist belt.
21 - fitting the footmuff
Unfasten the waist strap clips and shoulder strap clips. (See step 20.) Remove both chest pad and
crotch pad from the seat unit (a).
Unzip the footmuff cover and remove (b) Place the footmuff over the seat. Feed the harness straps
through the harness slots on the footmuff (c, d & e).
Attach the Velcro® strips at the top of the footmuff to the back of the seat (f).
Refit the crotch pad, chest pads and footmuff cover.
To remove the footmuff reverse the procedure above.
The two halves of the footmuff are reversible.
22 - fitting the seat hood
Place the hood on to the seat frame as shown.
Place the top of the hood mounts (a) over the chassis frame and then push hard on the bottom (b)
until the hood mounts clips in place.
To remove the hood pull the lip at the bottom of the hood mount away from chassis on both sides (c).
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cosatto Giggle 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cosatto Giggle 2 in the language / languages: English, Spanish as an attachment in your email.

The manual is 5,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info