668073
17
Zoom out
Zoom in
Previous page
1/20
Next page
17
TROUBLESHOOTING
1. ELECTRICAL SYSTEM SAFETY
The machine is fitted with a thermal trip unit with manual reset.
The brush motor is reset by resetting the thermal trip unit located beneath the handlebars.
If the machine stops repeatedly in a short space of time, you must contact the Comac
technical assistance centre.
2. INSUFFICIENT WATER ON THE BRUSHES
1. Check the solution tank filter is clean.
2. Check the solenoid valve switch is on.
3. Check the quick connection is correctly inserted.
4. Check the cock regulation screws on the water outlet.
5. Check the vent pin on the solution tank cap is lowered.
3. THE MACHINE DOES NOT CLEAN WELL
1. Check the state of wear and tear of the brushes and, if necessary, replace them. The
brushes should be changed when the bristles are about 15mm long.
4. THE SQUEEGEE DOES NOT DRY PERFECTLY
1. Check the squeegee rubbers are clean.
2. Check the suction tubes are correctly inserted in their housing on the squeegee.
3. Check the distributor is clean.
4. Replace the rubbers, if worn.
5. EXCESSIVE FOAM PRODUCTION
Check that a low foam detergent has been used. If necessary, add a small quantity of
antifoam liquid to the recovery tank.
Remember that, when the floor is not very dirty, more foam is generated. In this case the
detergent solution should be more diluted.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Comac VISPA 35E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Comac VISPA 35E in the language / languages: English as an attachment in your email.

The manual is 0,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info