669031

Cola Termo Diana Manual

13
Zoom out
Zoom in
Previous page
1/17
Next page
12
Termo Diana ceramic
3– HEATING STOVE USE
3.1 Introduction
Never leave children unsupervised in the vicinity of the stove; there is a very high risk of burns from the hot
surfaces.
Also:
- never use the stove with the fire door open;
- do not store firelighters or other easily combustible materials near the stove;
- do not move or lift the stove using the handles.
3.2 Startup
When lighting the stove the first time, bad odours may be created, therefore air the room thoroughly.
When lighting the stove the first time, allow it to burn with a low flame for many hours (ash door air control open
30%).
The heat can then be increased a little at a time, so that the stove expands slowly and the sealants and putties
dry.
3.3 Combustion air adjustment
The primary air is controlled by the thermostat located on the right of the box.
Optimum combustion conditions are obtained when, on loading wood, the air necessary for combustion
(controlled by the thermostat) enters through the grate.
3.4 Lighting and controlling the fire
To light the fire, it is advisable to use kindling and newspaper, or other means available on the market
(excluding any solid or liquid flammable and/or explosive substance).
During the lighting stage it is also advisable to open the bypass damper by pushing the knob towards the back
of the stove.
When the stove is hot, adjust the primary air as described is the following paragraph and close the damper by
pulling the lever towards the front of the stove.
Never use petrol, alcohol or other flammable liquids to light the fire.
3.5 Normal operation
Remove the ash from the grate every time before loading fuel. Put 2-3 logs of wood on the bed of embers for
even consumption and good efficiency.
Despite the large capacity of the combustion chamber, it is advisable to only load a max. of 2-3 logs at a time.
To obtain nominal heat output the hourly consumption of wood is approx. 7.8 kg. Overloading does not increase
efficiency, but will overheat the stove, damaging it.
3.6 Operation with slow combustion
Heat output can be controlled by reducing the combustion air. To guarantee operation for many hours at low
heat, the primary air control must be opened at minimum.
With partial feed operation, a patina may form on the glass due to the low temperature in the combustion
chamber.
In any case, a continuous fire with low output is not advisable.
3.7 Operation in off season
With outside temperatures above 15°C, the draught m ay be affected, resulting in a decrease in heat output and
therefore flue gases not completely exhausted (smell of smoke in the room). In this case it is advisable to
remove the ash from the grate and increase the combustion air. Put less fuel on the fire and clean the grate
more frequently.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cola Termo Diana at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cola Termo Diana in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info