669024

Cola Mary Manual

8
Zoom out
Zoom in
Previous page
1/11
Next page
7
Mary
If the walls and ceiling are made of flammable materials, the parts in contact with the flue must be suitably
insulated. All connection joints must be carefully sealed, in particular where the connection enters the flue.
If there are several stoves in the same home, each must have its own flue. It is inadvisable to make openings in
the flue for other appliances, since the draught could be negatively affected.
According to Standard UNI 7429, the chimney cap must meet several requirements; above all, it must have a
useful outlet cross section at least double that of the flue. It is also advisable
to install an "antiwind" cap that
guarantees fume exhaust even in the presence of strong horizontal winds.
NO YES YES
YES NO
3 – STOVE USE
3.1 Introduction
Never leave children unsupervised in the vicinity of the stove; the risk of burns caused by the hot parts is very
high.
Also:
-never use the stove with the firebox or ash door open;
-do not store firelighters or easily flammable materials near the stove;
-do not move or lift the stove using the handles.
3.2 Startup
When lighting the stove the first time, bad odours may be created, therefore air the room thoroughly.
When lighting the stove the first time, allow it to burn with a low flame for several hours (air control on ash door
open 30%).
The heat can then be increased a little at a time, so that the stove expands slowly and the paint and putty dry.
3.3 Lighting and controlling the fire
To light the fire, it is advisable to use small sticks of wood and newspaper, or other means available on the
market (excluding any solid or liquid flammable and/or explosive substance).
The air control on the ash door must be open, and is used for adjusting stove heat output after the lighting
stage.
The secondary air also keeps the glass clean, therefore it is advisable to always keep this air control slightly
open when the stove is hot.
The ash door must always be closed when the stove is operating, to avoid damage due to overheating
of the stove.
3.4 Normal operation
Remove the ash from the grate every time before loading fuel. Put 2-3 logs of wood on the bed of embers.
Despite the large capacity of the combustion chamber, it is advisable to only load a max. of 2-3 logs at a time.
Overloading does not increase efficiency, but will overheat the stove, damaging it.
3.5 Operation with partial feed
Heat output can be controlled by reducing the combustion air. To guarantee operation for many hours at low
heat, the primary and secondary air valves must only be opened at minimum. With partial feed operation, a
patina may form on the glass due to the low temperature in the fire zone. In any case, a continuous fire with low
output is not advisable.
Fig. 4 Chimney caps
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cola Mary at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cola Mary in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info