580517
13
Zoom out
Zoom in
Previous page
1/137
Next page
24 25
8. INSTALLATION / WIRE CONNECTION
GUIDE
Source unit .................................................... 1
Front panel .................................................... 1
Trim plate ...................................................... 1
Owner’s manual ............................................ 1
Screws M5 × 6 mm ....................................... 4
L-key ............................................................. 2
Rubber cushion............................................. 1
Wire connector ............................................. 1
Remote control unit (with battery) ................. 1
DCP case...................................................... 1
Microphone ................................................... 1
2) Package Contents
3) General Cautions
1. Do not open the main unit body. There
are no user- serviceable parts inside.
If you drop anything into the unit dur-
ing installation, consult your dealer or
an authorized Clarion service center.
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, alcohol, etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe o the dirt gently.
CONTENTS
1) BEFORE STARTING ............................................................. 24
2) PACKAGE CONTENTS ......................................................... 24
3) GENERAL CAUTIONS .......................................................... 24
4) CAUTIONS ON INSTALLATION ............................................ 25
5) INSTALLING THE SOURCE UNIT ......................................... 25
6) REMOVING THE SOURCE UNIT .......................................... 27
7) WIRING AND CONNECTIONS.............................................. 28
8) CONNECTING THE ACCESSORIES .................................... 29
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “–” terminal
before starting. This is to prevent short circuiting
during installation. (Figure 1)
1) Before Starting
Car battery
Figure 1
4) Cautions on Installation
1. Prepare all articles necessary for in-
stalling the source unit before starting.
2. Install the unit within 30° of the hori-
zontal plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult
your car dealer beforehand.
Max 30°
Figure 2
4. Use the enclosed screws for installa-
tion.
Using other screws can cause dam-
age.
(Figure 3)
Figure 3
Max. 6 mm (M5 screw)
Chassis Chassis
Damage
5) Installing the Source Unit
1. Place the mounting bracket into the instrument panel, use a screwdriver to bend
each stopper of the universal mounting bracket inward, then secure the stopper.
2. Wire as shown in Section 7.
3. Insert the source unit into the mounting bracket until it locks.
4. Take care of the top and bottom of the outer escutcheon and mount it so that all the
hooks are locked.
Notes:
1. Some car models require special mounting kits for proper installation.
Consult your Clarion dealer for details.
2. Fasten the front stopper securely to prevent the source unit from coming loose.
• Console opening dimensions
(182 mm)
7-3/16"
2-1/8"
53 mm
Hole
English PolskiFrançais Deutsch Italiano Nederlands Español Svenska 
English PolskiFrançais Deutsch Italiano Nederlands Español Svenska 
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clarion CZ309E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clarion CZ309E in the language / languages: English as an attachment in your email.

The manual is 16,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info