650695
53
Zoom out
Zoom in
Previous page
1/136
Next page
Configuring the Voice Settings
Provisioning
Cisco SPA100 Series Administration Guide 61
1
Resync Error Retry
Delay
Resync retry interval (in seconds) applied in case of resync failure.
The ATA has an error retry timer that activates if the previous
attempt to sync with the provisioning server fails. The ATA waits
to contact the server again until the timer counts down to zero.
This parameter is the value that is initially loaded into the error
retry timer. If this parameter is set to zero, the ATA immediately
retries to sync with the provisioning server following a failed
attempt.
Default setting: 3600
Forced Resync Delay Maximum delay (in seconds) that the ATA waits before performing
a resync.
The ATA does not resync while one of its lines is active. Because a
resync can take several seconds, it is desirable to wait until the
ATA has been idle for an extended period before resynchronizing.
This allows a user to make calls in succession without interruption.
The ATA has a timer that begins counting down when all of its
lines become idle. This parameter is the initial value of the counter.
Resync events are delayed until this counter decrements to zero.
Default setting: 14400
Resync From SIP Enables a resync to be triggered via a SIP NOTIFY message.
Default setting: yes
Resync After
Upgrade Attempt
Triggers a resync after every firmware upgrade attempt.
Default setting: yes
Resync Trigger 1
Resync Trigger 2
Configurable resync trigger conditions. A resync is triggered when
the logic equation in these parameters evaluates to TRUE.
Default setting: blank
Resync Fails On FNF Determines whether a file-not-found response from the
provisioning server constitutes a successful or a failed resync. A
failed resync activates the error resync timer.
Default setting: yes
Field Description
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco Cisco SPA112 VoIP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco Cisco SPA112 VoIP in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info