497619
30
Zoom out
Zoom in
Previous page
1/74
Next page
3-4
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 3 Installing the Adaptive Security Appliance
Installing the Adaptive Security Appliance
Figure 3-4 Attaching the Rubber Feet
Step 4
Place the chassis right-side up on a flat, smooth, secure surface.
Step 5 Connect the interface cables. See the “Connecting the Interface Cables” section on page 3-4 for more
information.
Connecting the Interface Cables
This section describes how to connect the cables to the Console, Management, 4GE SSM, and SSM ports.
In this document, SSM refers to an intelligent SSM, the AIP SSM or CSC SSM.
Note You can use any unused Ethernet interface on the device as the failover link. The failover link interface
is not configured as a normal networking interface; it should only be used for the failover link. You can
connect the LAN-based failover link by using a dedicated switch with no hosts or routers on the link or
by using a crossover Ethernet cable to link the units directly. For more information, see the Cisco Security
Appliance Command Line Configuration Guide.
Warning
Only trained and qualified personnel should install, replace, or service this equipment
.
Statement 49
Caution Read the safety warnings in the Regulatory Compliance and Safety Information for the Cisco ASA 5505
Adaptive Security Appliance and follow proper safety procedures when performing these steps.
1 Rubber feet
132185
1
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ASA 5510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ASA 5510 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info