497619
31
Zoom out
Zoom in
Previous page
1/74
Next page
3-5
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 3 Installing the Adaptive Security Appliance
Installing the Adaptive Security Appliance
Note The RJ-45 Auxiliary port (labeled AUX on the chassis) is reserved for internal use at Cisco. The port is
not functional in shipping versions of the chassis; therefore, customers cannot connect to this port to run
the adaptive security appliance CLI.
To connect cables to the ports perform the following steps:
Step 1 Place the chassis on a flat, stable surface, or in a rack (if you are rack-mounting it.)
Step 2 Before connecting a computer or terminal to the ports, check to determine the baud rate of the serial port. The
baud rate must match the default baud rate (9600 baud) of the Console port of the adaptive security
appliance. Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop bits, and Flow
Control (FC) = Hardware.
Step 3 Connect the cables to the ports.
a. Management port
The adaptive security appliance has a dedicated management interface referred to as the Management0/0
port. The Management0/0 port is a Fast Ethernet interface with a dedicated port used only for traffic
management.
Note You can configure any interface to be a management-only interface using the management-only
command. You can also disable management-only mode on the management interface. For more
information about this command, see the management-only command in the Cisco Security
Appliance Command Reference.
Connect one RJ-45 connector to the Management0/0 port, as shown in Figure 3-5.
Connect the other end of the Ethernet cable to the management port on your computer or
network device.
Figure 3-5 Connecting to the Management Port
1 Management port 2 RJ-45 to RJ-45 Ethernet cable
USB2
USB1
LNK SPD
3
LNK SPD
2
LNK SPD
1
LNK SPD
0
MGMT
92684
2
1
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ASA 5510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ASA 5510 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info