788776
7
Zoom out
Zoom in
Previous page
1/24
Next page
7
®
FOREWORD:
The soft one-touch electroluminescent keypad has 12 keys; (see fig. 1) an acoustic signal
can be heard each time a key is pressed.
- 10 numerical keys from 0 to 9 and 26 letters.
- There are 1,111,111,110,000 possible combinations.
- The ENTER key confirms the code that has been entered.
- The CLEAR key deletes all previously entered letters and numbers.
All safes are supplied with the service code “555555”.
INSTALLATION:
Doors on wall safes must be left open for 2/4 days after installation.
After the safe has been installed insert four new 1.5 V alkaline batteries in the battery
compartment on the inside of the door (fig. 2), (use only alkaline batteries).
In order to enter your personal safe combination code read the following “INSTRUCTIONS
FOR USE” carefully.
INSTRUCTIONS FOR USE:
OPERATION 1
STORING A PERSONAL CODE
THIS OPERATION MUST BE PERFORMED WITH THE DOOR OPEN.
Get a pencil (which will be used to press the zero reset button).
a) Turn the knob counter-clockwise to shoot the bolts.
b) Type “555555” and press .
The green led will light for 10 sec.
c) Before the 10 seconds have elapsed press the reset button on the inside of the door using
the end of a pencil (see fig.3).
An acoustic signal will be heard and the green led will illuminate for 20 seconds .
d) Before the 20 seconds have elapsed type your personal code (min. 4 digits, max. 12) and
press .
The red led will illuminate for 20 seconds .
e) Before the 20 seconds have elapsed enter your personal code again and press the ENTER
key .
If the personal code has been correctly stored the two leds will switch off .
OPERATION 2
PERSONAL CODE VERIFICATION
THIS OPERATION MUST BE PERFORMED WITH THE DOOR OPEN.
a) Type your personal code and press .
The green led will illuminate for 10 seconds :
effective time for drawing back bolts with
knob.
b) Draw back the bolts with the knob.
c) Repeat the aforementioned steps several times to check locking and unlocking operations.
OPERATION 3
LOCKING THE DOOR:
a) Remove the nylon safety plug that blocks one of the holes on the striker.
b) Close the door and turn the knob counter-clockwise to shoot the bolts.
GB
PENCIL
Fig. 3
Fig. 2
Fig. 1
INSTRUCTIONS FOR SAFE WITH ELECTRONIC
COMBINATION LOCK
ZERO RESET
BUTTON
BATTERIES
EXTERNAL POWER INPUT
LEDS
0.606.52.86.0_1 10-10-2005, 12:067
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisa Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisa Vision in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info