588931
36
Zoom out
Zoom in
Previous page
1/38
Next page
36
9.4 Update the HAC5 firmware
To update the HAC5 firmware, prepare the HAC5 for pc data transfer as shown in chapter 9.3.
Note: Firmware-Update should only be done if battery shows at least 50%.
To update, only the program HAC
tronic can be used. Choose there the firmware update function.
Enter the according firmware data on the next screen and click “start”. The update starts automati-
cally.
10. Changing the batteries
HAC5:
Unscrew the battery cap on the back of the HAC5 to the left with the aid of a coin. Remove old battery
and insert new 3V-Lithium battery type CR2032 with the plus pole facing up, please make sure that
the contacts lie on the battery. Replace battery cap and screw tightly. Do not over twist battery cap!
Attention: If the values and adjustments of the HAC5 are to be maintained during the battery change,
the power-down mode should be switched on before the battery is changed (main setting mode, see
chapter 6.7). If no characters or unintelligible characters appear in the display after the battery change,
remove battery again, wait 10 sec. and insert battery again.
Speed- and cadence transmitter:
Unscrew the battery cap with a coin and remove old battery. Insert new battery type CR2032 with
the plus pole facing up and replace the cap. Do not over twist battery cap!
Heart rate transmitter:
Unscrew the battery cap with a coin and remove old battery. Insert new battery type CR2032 with
the plus pole facing up and replace the cap. Do not over twist battery cap!
Please do not discard used batteries in domestic waste, but discard them on your local
recycling-point.
11. Service and maintenance
Protect from direct sunlight, heat and frost (below 0°C and over 50°C).
Keep the heart rate transmission belt clean:
Do not wash the transmitter belt in a washing machine, due to the attached electrodes. To clean the
transmitter belt, wipe it carefully with a detergent for synthetic fabrics. Do not dry in direct sunlight.
The elastic chest belt is washable, but it must be carefully dried before use.
12. Trouble shooting
Faulty or no display
No reaction of the buttons
• Check and/or replace battery
Current speed is not displayed
Speed is too high or too low
• Check if function “Speed” is switched on in setting mode
• Check transmitter and magnet for correct installation
• Check if magnet is placed correctly on the spoke
(directly opposite the mark of the transmitter with a maximum of 3 mm distance)
• Transmitter battery empty or transmitter faulty
• Check distance between handlebar bracket and transmitter (max. 2 m)
• check adjusted wheel circumference
• check unit of measure
• start transmitter search again by pressing LL-button for three seconds
Cadence is not displayed
• Check if function “Cadence” is switched on in setting mode
• Check transmitter and magnet for correct installation
• Transmitter battery empty or faulty
• start transmitter search again by pressing LL-button for three seconds
Heart rate is not displayed or values displayed are incorrect or unstable
• Check if function “Heartrate” is switched on in setting mode
• check transmitter belt (battery)
• skin too dry / too cold
• distance between HAC5 and transmitter belt is too big (max. 10 m)
• start transmitter search again by pressing the LL-button for three seconds
Manual switch to 2nd bike profile doesn’t work
• check if speed is at zero (only then is a switch possible)
Initialization runs very slow or breaks off with “error”
• transmitter battery empty or transmitter faulty
• transmitter (speed- or cadence) is already initialized for other bike. Should the transmitter be
Update the
HAC5
firmware
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ciclo HAC 5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ciclo HAC 5 in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ciclo HAC 5

Ciclo HAC 5 Additional guide - English - 4 pages

Ciclo HAC 5 Additional guide - German - 4 pages

Ciclo HAC 5 Quick start guide - German - 2 pages

Ciclo HAC 5 User Manual - German - 38 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info