574371
9
Zoom out
Zoom in
Previous page
1/12
Next page
IRIS Touch and Honeywell GT Dialler Installation Guide for LPS1277 compliance V1.3
June 2014
5
Notes.
a)
The phrase 'direct alarm protection' shall mean that sufficient detection devices are
installed to ensure that, when the I&HAS is set, access to the protected equipment
results in a full (e.g. a ‘confirmed’) alarm condition. Where an I&HAS uses a time
delayed entry/exit route as part of the facility for unsetting, detection devices
programmed to act as entry/exit route detection shall not be regarded as providing
‘direct protection’.
b)
The phrase ‘Site Network Equipment’ shall be regarded as all equipment installed
within the alarmed premises through which signals from the SPT to the alarm
transmission network beyond the perimeter of the premises are transmitted. For
example, non-alarm dedicated (shared use) IP routers, telephone
switchboards/Private Automatic Branch Exchanges (PABX), network access
termination points, ATP aerials and communication network junction boxes/switches.
3.1.4. ARC/ATS message holding
Where the Alarm Receiving Centre (ARC) &/or ATS provider offers, or requests
use of, a facility to block the receipt of, or hold information relating to, ATS fault
notification signals or messages pending receipt of further alarm information
(e.g. pending the designation of a confirmed alarm as per BS 8243), agreement
to such an action shall be confirmed in writing by the customer (end user); with
the relevant notification stating that this action is compatible with the risk
assessment and/or the requirements of any interested party, for example an
insurer.
In such cases the installer shall make suitable arrangements, which shall be
confirmed in writing, for the customer to be alerted to any such ATS fault
notification signals/messages when their alarm system is next unset, or after a
period of 96 hours, whichever is the sooner.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chiron IRIS Touch - Dialler LPS 1277 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chiron IRIS Touch - Dialler LPS 1277 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info