Manual Charnwood LA20i (page 4 of 16) (English)

815487

Zoom out

Zoom in

1/16

At first you may find it helpful to try several fuels to find the

most suitable. If you are unable to obtain the fuel you want

ask your supplier, an approved fuel distributor, or the Solid

Fuel Association (tel. 0800 600 000) to suggest an

alternative.

Use the spanner type tool to open and close the doors. Turn

the knob on the right hand door anti-clockwise to open and

clockwise to close. When closing the doors do not push on

the enamel with the tool as this can chip the enamel, instead

push the doors on the door knobs.

Place some paper and dry kindling wood or fire lighters on

the grate and cover with a small amount of fuel. Turn the

thermostat control knob to the maximum setting and light the

paper or fire lighters. Close the doors and allow the fire to

burn until the fuel is well ignited then load with more fuel and

adjust the thermostat to the required level.

On initial lighting, the fire may smoke and give off an odour as

the silicon paint with which the firebox is painted reacts to the

heat. This is normal and will cease after a short time. In the

meantime the room should be kept well ventilated.

Before relighting the fire, riddle, remove any clinker from the

firebed and empty the ashpan.

The rate of burning and hence the output is controlled by the

control knob on the left hand side of the appliance, shown in

Fig. 1. This is linked to a thermostat which controls the

firebox temperature. The number at the top of the knob is

the number at which it is set. Some experimentation may be

necessary to obtain the desired heat output.

There is also a manual secondary air control which is located

above the door opening as shown in Fig. 2. To adjust the

setting, open the doors and use the door opening tool to

move the flap to the desired position. This control should be

in the closed position when burning any of the recommended

smokeless fuels except for anthracite and homefire which

should be burnt with the secondary air inlet open.

DOOR OPERATION

LIGHTING

CONTROLLING THE FIRE

For correct firing we recommend the use of a stove pipe

thermometer which may be purchased from your supplier or from

ourselves.

Before lighting the fire check with the installer that the work

and checks described in the installation instructions have been

carried out correctly and that the chimney has been swept, is

sound, and free from any obstructions.

WARNING There must not be an extractor fan fitted in the

same room as this appliance as this can cause the appliance to

emit smoke and fumes into the room.

If the appliance is fitted in place of an open fire then the

chimney should be swept one month after installation to clear

any soot falls which may have occurred due to the difference

in combustion between the appliance and the open fire.

When using the fire in situations where children or infirm

people are present please use a fire guard to prevent

accidents. The fire guard should be manufactured in

accordance with BS 6539.

This appliance obtained approval by HETAS Ltd. in the safe

and fit for purpose category.

HETAS Ltd. approval only covers the use of the following

smokeless fuels on this appliance:

Ancit (Phurnacite Plus),

Anthracite Large Nuts,

Cosycoke,

Centurion,

Extracite,

Maxibrite,

Phurnacite,

Sunbrite Doubles,

Welsh Dry Steam Coal (Large Nuts).

Approval does not cover the use of other fuels either alone or

mixed with the above fuels, nor does it cover instructions for

the use of other fuels.

The above fuels are all suitable for use in smoke control areas.

In non-smoke control areas your Housing Authority will be

able to advise you if other fuels may be burnt. For instructions

on burning other fuels please ask your your supplier or

Housing Authority for the “Charnwood Instruction

Supplement.”

FUELS

PETROLEUM COKE IS NOT SUITABLE FOR USE ON

THIS APPLIANCE, ITS USE WILL INVALIDATE THE

GUARANTEE

charnwood

OPERATING INSTRUCTIONS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood LA20i in the language / languages: English as an attachment in your email.

The manual is 0.43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood LA20i Manual

Product: