815471

Charnwood Haven Manual

6
Zoom out
Zoom in
Previous page
1/20
Next page
6
®
When relighting the stove, leave the ash on the base, unless it is
becoming too deep, in which case some of it may be removed by
riddling the grate to empty it into the ashpan.
CONTROLLING THE FIRE
The rate of burning and hence the output is controlled by the air
control (see Fig.1)
Open the air control fully (high position) when lighting or when rapid
burning is required. It should not be left fully open for long periods
as this can cause over-firing or excessive smoke production. For most
efficient output move the air control to the ‘nominal position’ or for
low burning to the low position.
When the fire is burning normally the air control gives enough
airwash to keep the glass clean. However, it will not always be
possible to keep the glass clean with the air control fully closed. For
correct firing we recommend the use of a stove pipe thermometer
which may be purchased from your supplier or from Charnwood.
The Charnwood Haven is fitted with an air control stop for use in a
smoke control area. This stops the stove from burning too slowly.
WOOD ASH REMOVAL GRATE
Your Charnwood Haven is fitted with a wood ash removal grate to
enable wood to be burned and ash to be cleared.
Movement of the grate from one position to the other is effected
using the operating tool supplied as shown in Fig.2.
The grate is put into the open position by turning the operation tool
anticlockwise. The grate is put into the closed position by turning
the operation tool clockwise. To riddle the appliance the tool should
be moved between the clockwise and anticlockwise positions several
times. When burning wood, the grate must be in the ‘open’ position
as shown in Fig.2.
RIDDLING
When burning wood, ash should be allowed to build up and only
riddled when the ash begins to cover the rear fireplate. The fire
should be riddled with the fire door shut (see Fig.2). Place the
operating tool into the riddling lever and rotate between the open
and closed positions several times. Too much riddling can result
in emptying unburnt fuel into the ashpan and should therefore be
avoided. After riddling, the grate should be put back into the open
position.
Fig. 2 Riddling
OPERATING INSTRUCTIONS
Nominal
click
High
Output Low
Output
AIR CONTROL
Oven handle
Pull to open
Riddling knob
Use the operating tool to
riddle. The stove should be
run with the grate in the
‘open’ position. (See fig. 2)
Operating
tool storage
Store the
operating tool
when not in
use
Oven
thermometer
Indicates
approximate oven
temperature
Serial label
Slide out to view,
scan QR code to
register.
Cooking plate
The temperature of the cooking plate is graded, with the hottest point
located directly above fire for boiling.
Flue Diverter
Forward ( Position 1) -
Lighting
Back (Position 2) -
Normal operation
Fire Door Handle
Twist clockwise to
open
Fig. 1. Stove Controls
Open
Riddle
Closed
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Haven at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Haven in the language / languages: English as an attachment in your email.

The manual is 2.97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info