632314
9
Zoom out
Zoom in
Previous page
1/16
Next page
HEALTH & SAFETY PRECAUTIONS
This is particularly necessary if the room is double
glazed. It must be positioned such that it is not liable to blockage.
In addition to these instructions the requirements of BS.8303 and
BS EN 15287-1:2007 must be fulfilled. Local Authority Bylaws and
Building Regulations regarding the installation of Solid Fuel burning
appliances, flues and chimneys must also be observed, including those
referring to national and European Standards.
SPECIFICATION
The outputs were obtained burning:
1) Seasoned hardwood over a 1.5 hourly refuelling cycle.
2) Welsh Anthracite over a 4 hourly re-fuelling cycle.
Please take care when installing the stove that the requirements of
the Health and Safety at Work Act 1974 are met.
Some types of fire cement are caustic and should not be allowed to
come into contact with the skin. In case of contact wash with plenty
of water.
If there is a possibility of disturbing any asbestos in the course of
installation then please use appropriate protective equipment.
There must not be an extractor fan fitted in the same room as the
stove as this can cause the appliance to emit fumes into the room.
There must be an adequate air supply into the room in which the
appliance is installed to provide combustion air. The combustion air
supply must be via a permanently open vent. The minimum free area
is 62.7cm (9.7 in ).
CHIMNEY
HEARTH AND FIRE SURROUND
The stove must stand on a fireproof hearth and must be situated at
least the following distances from any combustible material:
In order for the appliance to perform satisfactorily the chimney height
must not be less than 4 metres measured vertically from the outlet of
the stove to the top of the chimney. The minimum internal chimney
size is
This stove is to be used in a shared flue. If an existing chimney is
to be used it must be swept and checked, it must be in good
condition, free from cracks and blockages, and should not have an
excessive cross sectional area. If you find that the chimney is in poor
condition then expert advice should be sought regarding the necessity
of having the chimney lined. If it is found necessary to line the
chimney then a lining suitable for Solid Fuel must be used.
If there is no existing chimney then a prefabricated block chimney or
a twin walled insulated stainless steel flue to with BS EN 15287-1:
2007 can be used either internally or externally. These chimneys
must be fitted in accordance with the manufacturers instructions and
Building Regulations.
Anki pumice liners or chimney blocks will give a highly insulated
chimney which will work well with all fuels. For details ring Anki
Chimney Systems on (01983) 527997.
Single wall flue pipe is suitable for connecting the stove to the
chimney but is not suitable for using for the complete chimney.
If it is found that there is excessive draw in the chimney then a
draught stabiliser should be fitted.
It is important that there is sufficient draw in the chimney and that
the chimney does not suffer from down-draught. When the chimney
is warm the draw should be not less than 0.1 inches water gauge. If in
doubt about the chimney seek expert advice.
The hearth must be at least 12mm (0.5inches) thick. The positioning
of the stove and the size of the hearth are governed by building
regulations for Class 1 appliances. These building regulations state
that the hearth must extend in front of the stove by at least 300mm
(12 inches) and to the sides of the stove by at least 150mm (6
inches). When the fire door is open, it extends beyond the front of
the stove by 414mm (16.3in).
If in doubt as to the positioning of the stove expert advice should be
150mm diameter (6 inches) or 150mm x 150mm.
NOT
Side 100mm (4in)
Back 100mm (4in)
®
9
charnwood
INSTALLATION INSTRUCTIONS
Specification
Wood
Anthracite
Nominal Heat Output (kw)
11 (37,533 Btu/h)
16.4 (55,960 Btu/h)
Space Heating Output (kw)
4.6 (15,696 Btu/h)
7.1 (24,226 Btu/h)
Water Heating Output (kw)
6.4 (21,828 Btu/h)
9.3 (31,733 Btu/h)
Normal Flue Gas Temp (°C)
315
353
Flue Gass Mass Flow g/s
8.6
11.6
Max Water Pressure Bar (ft. H O)
1.5 (50)
Min Distance From Combustibles and also for access:
Sides (mm)
100
Back (mm)
100
Max Hearth Temp (°C)
53
Min Flue Draught Pa (in water)
25 (0.1)
Boiler Capacity Litres
8.4
Weight (kg)
Low Stand
127
Store Stand
133
Centre Stand
146
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Cove 2B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Cove 2B in the language / languages: English as an attachment in your email.

The manual is 0,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Charnwood Cove 2B

Charnwood Cove 2B User Manual - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info