740165
22
Zoom out
Zoom in
Previous page
1/58
Next page
Switching Between Heart Rate Data
Display Screens
Each press of (A) in the HR (Heart Rate) Mode
toggles between the screens shown below.
Normal
Run Timing
The Heart Rate Graph shows data for up to
30 minutes or for up to 24 hours.
Each reading plotted along the horizontal
axis shows the range between the
maximum and minimum measured values
during a 15-second or 12-minute interval.
Starting Heart-rate Training
With heart-rate training, you measure your
heart rate and then use the resulting value as
a benchmark for training. You can monitor
your heart rate levels and keep your exercise
intensity in line with your training goals, which
contributes to more efficient training,
improved cardiopulmonary function, and
better health.
Specifying a Target Heart Rate Zone
Specify a target heart rate zone that matches
your training objectives.
Your heart rate changes in accordance with
your exercise intensity. The five heart rate
zones of your watch, which are numbered
from 1 to 5, are determined based on
percentages of your maximum heart rate. The
greater the zone number, the higher the
exercise intensity level.
Zone 1 (50 to 60%*): Warm up
Used for warm up at the beginning of an
exercise session and cool down at the end.
Zone 2 (61 to 70%*): Fat burning
Promotes metabolism and burns fat. Better
than more rigorous training for increasing
physical ability.
Breathing is comfortable, which is good for
prolonged training. Start of perspiration.
Zone 3 (71 to 80%*): Aerobic training
Improves basic endurance and athletic
performance.
Breathing is easy, light perspiration.
Zone 4 (81 to 90%*): Anaerobic training
Improves endurance exercise performance
and basal metabolism.
Breathing is heavier, increased
perspiration.
Zone 5 (91 to 100%*): Maximum effort
Improves athletic performance and
instantaneous power.
The physical load is high, so this zone
should be maintained for short periods.
Recommended for occasional training or for
athletes who train daily.
*
Percent of maximum heart rate
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Press (C).
This displays the GPS signal receive start
screen.
3. Press (D) to enter the HR (Heart Rate)
Mode.
4. Hold down (A) for at least two seconds.
This displays the HR (Heart Rate) Mode
setting screen.
Pointer
5. Use (A) and (D) to move the pointer to
[TARGET].
6. Press (C).
7. Use (A) and (D) to move the pointer to the
heart rate zone you want to specify as your
target.
8. Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the HR (Heart
Rate) mode setting screen will re-appear.
9. Press (E) to exit the setting screen.
Setting Up the Heart Rate Zone Alert
If you engage in heart-rate training while the
heart rate zone alert is enabled, the watch will
perform a sound and/or vibration operation to
let you know when your current heart rate is ±5
bpm or greater outside of the zone currently
specified as your target. If you do not re-enter
the target zone after the alert, an out-of-zone
alert operation will be performed at one-
minute intervals.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Press (C).
This displays the GPS signal receive start
screen.
3. Press (D) to enter the HR (Heart Rate)
Mode.
4. Hold down (A) for at least two seconds.
This displays the HR (Heart Rate) Mode
setting screen.
Pointer
Operation Guide 3475
22
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio QW3475 - GBD-H1000 G-SQUAD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio QW3475 - GBD-H1000 G-SQUAD in the language / languages: English as an attachment in your email.

The manual is 4,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info