624481

Casio 5240 - GW-A1000 Manual

2
Zoom out
Zoom in
Previous page
1/9
Next page
Operation Guide 5240
E-19
If your Home City Code setting is this:
The watch can receive the signal from
the transmitter located here:
LON (LONDON), PAR (PARIS), ATH (ATHENS)
Anthorn (England), Mainfl ingen
(Germany)
HKG (HONG KONG) Shangqiu City (China)
TYO (TOKYO)
Fukushima (Japan), Fukuoka/Saga
(Japan)
HNL (HONOLULU), ANC (ANCHORAGE),
LAX (LOS ANGELES), DEN (DENVER),
CHI (CHICAGO), NYC (NEW YORK)
Fort Collins, Colorado (United States)
Important!
The areas covered by
x HNL (HONOLULU) and ANC (ANCHORAGE) are quite far
from the calibration signal transmitters, so certain conditions may cause reception
problems.
E-18
Radio Controlled Atomic Timekeeping
This watch receives a time calibration signal and updates its time setting accordingly.
However, when using the watch outside of areas covered by time calibration signals,
you will have to adjust the settings manually as required. See “Confi guring Current
Time and Day Settings Manually” (page E-39) for more information.
This section explains how the watch updates its time settings when the city code
selected as the Home City is in Japan, North America, Europe, or China, and is one
that supports time calibration signal reception.
E-17
Power Saving
Power Saving enters a sleep state (second hand sleep or function sleep) whenever
the watch is left for a certain period in an area where it is dark.
Elapsed Time in Dark Operation
60 to 70 minutes
(second hand sleep)
x
x
Second Hand only stopped at 12 o’clock, all other functions
enabled
6 or 7 days
(function sleep)
All functions, including analog timekeeping, disabled x
Internal timekeeping maintained x
The watch will not enter a sleep state between 6:00 AM and 9:59 PM. If the watch is x
already in a sleep state when 6:00 AM arrives, however, it will remain there.
The watch will not enter a sleep state while it is in the Stopwatch Mode or
x
Countdown Timer Mode.
To recover from the sleep state
Move the watch to a well-lit area or press any button.
E-16
Charging Times
Exposure Level (Brightness)
Daily
Operation *1
Level Change *2
Level 3 Level 2 Level 1
Outdoor sunlight (50,000 lux) 8 minutes 3 hours 28 hours
Window sunlight (10,000 lux) 30 minutes 7 hours 107 hours
Window sunlight on cloudy day
(5,000 lux)
48 minutes 10 hours 173 hours
Indoor fl uorescent lighting
(500 lux)
8 hours 114 hours – – –
1 Approximate exposure each day to generate power for normal daily operation. *
2 Approximate exposure to take power up one level. *
The above times are for reference only. Actual times depend on lighting conditions.
x
For details about the operating time and daily operating conditions, see the “Power x
Supply” section of the Specifi cations (page E-84).
E-15
When power drops to Level 3, all settings (including timekeeping) will be cleared. x
Recharging the battery will reset all settings to their initial factory defaults.
When the watch is at Level 3, exposing it to light for a while will cause the x
x
Second
Hand to move to the position of second 57. This indicates that charging has started.
Power Recovery Mode
The watch is designed to go into a power recovery mode that stops hand operation
temporarily whenever power suddenly drops below a certain level due to continuous
signal reception or other operations over a short period. Note that all operations are
disabled while the watch is in the power recovery mode.
The hands will move to the correct positions and the watch will resume normal
operation after power recovers (in about 15 minutes). Putting the watch in a location
where it is exposed to light will help power to recover sooner.
E-14
Low Power
Low power conditions are indicated by the movement of
the
x
Second Hand in the Timekeeping Mode.
If the x
x
Second Hand is moving normally at one-second
intervals, power is at Level 1.
If the
x
x
Second Hand is moving at two-second intervals,
power is at Level 2, which is quite low. Expose the watch
to light as soon as possible so it can charge.
Low Battery Alert (Hand Movement and Function
Status)
Level Hand Movement Function Status
1 Normal. All functions enabled
2
x
x
Second Hand moves at
two-second intervals.
Beeper and time
calibration signal
reception disabled.
3
x
x
Second Hand stopped.
All functions disabled

@
Moves at two-second
intervals.
E-13
Warning!
Leaving the watch in bright light for charging can cause it to become quite hot.
Take care when handling the watch to avoid burn injury. The watch can become
particularly hot when exposed to the following conditions for long periods.
On the dashboard of a car parked in direct sunlight
x
Too close to an incandescent lamp x
Under direct sunlight x
Important!
Keep the watch in an area normally exposed to bright light when storing it for long
x
periods. This helps to ensure that power does not run down.
Storing the watch for long periods in an area where there is no light or wearing it in
x
such a way that it is blocked from exposure to light can cause power to run down.
Make sure that the watch is exposed to bright light whenever possible.
Checking the Current Power Level
Certain functions will be disabled when the power level is low. If the power level is
low, leave the watch in a location where its face (solar panel) is exposed to light.
E-12
Charging the Watch
The face of the watch is a solar panel that generates power from light. The generated
power charges a built-in rechargeable battery, which powers watch operations. The
watch charges whenever it is exposed to light.
Charging Guide
Whenever you are not
wearing the watch, be sure
to leave it in a location
where it is exposed to light.
Best charging
x
performance is achieved
by exposing the watch to
light that is as strong as
possible.
When wearing the watch,
makes sure that its face is
not blocked from light by
the sleeve of your clothing.
The watch may enter a
x
sleep state (page E-17)
if its face is blocked by
your sleeve even only
partially.
E-11
E-67 To stop the alarm
E-68 Adjusting Home Positions
E-70 To adjust home positions
E-72 Troubleshooting
E-82 Specifi cations
E-10
E-52 Temperature Reading Precautions
E-53 Checking the Current Time in a Different Time Zone
E-54 To view the time in another time zone
E-57 To swap your Home City and World Time City
E-58 Using the Stopwatch
E-59 To enter and exit the Stopwatch Mode
E-59 To perform an elapsed time operation
E-59 To perform fl yback timing
E-61 Using the Countdown Timer
E-62 To specify the countdown start time
E-63 To perform a countdown timer operation
E-63 To stop the alarm
E-64 Using the Alarm
E-65 To change the alarm time setting
E-67 To turn the alarm on or off
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5240 - GW-A1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5240 - GW-A1000 in the language / languages: English as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5240 - GW-A1000

Casio 5240 - GW-A1000 User Manual - German - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info