816488

Carat BS-1805 Manual

43
Zoom out
Zoom in
Previous page
1/114
Next page
43
GB
Side Handle..........................................1
Lock Nut Wrench................................1
Face Spanner Wrench .......................1
L-Hex Wrench.......................................1
Flanges...................................................2
RECOMMENDED ACCESSORIES
This machine may only be used with diamond cup wheels of 125mm diameter for BS-1255 and 180mm for
BS-1805 with 25.4mm (1") or 22.23mm (7/8") arbor hole or with M14 female thread.All other uses are
prohibited.
Bonded abrasive accessories are not allowed to be used with this machine.
BASIC OPERATION
NOTE: Make sure that the power circuit voltage is the same as that shown on the specification plate of
the machine and that switch is “OFF” before connecting the tool to the power circuit.
THE SWITCH
The machine has a lockable trigger switch. Squeeze the trigger to
start the machine. To lock the switch on, press the lock button while
holding the trigger switch on.
To release, squeeze the trigger and release.
CAUTION: After the machine has been switched off, the spindle
will continue rotating. Take care that parts of your body do not
come into contact with the rotating parts or set the machine down while it is still rotating!
HOW TO USE THE TOOL
Effective control of this machine requires two-handed operation for maximum protection and resistance to
the start-up and operating torque. Place the work properly and hold the machine firmly WITH BOTH HANDS
to prevent loss of control, which could cause personal injury. Protect your eyes from injury with safety glasses
or goggles.
OVERLOAD
This machine is equipped with overload protection which will shut off the motor if the maximum allowable
current is exceeded. If the overload trips, remove from the work surface, release the switch and then switch
back on. The machine will restart.
CAUTION: Whenever the machine overloads, always run the machine at no load for a few minutes to
allow the temperature to return to normal before proceeding to work.
Trigger Switch
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carat BS-1805 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carat BS-1805 in the language / languages: English, German, Dutch, Danish, French, Swedish, Norwegian as an attachment in your email.

The manual is 3.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info