475743
13
Zoom out
Zoom in
Previous page
1/20
Next page
Deutsch
English
Installation instructions
If you do not have the loudspeaker system installed by a specialist you are recommended to follow these general installation
instructions:
Safety Disconnect the negative terminal of the vehicle battery.
Polarity When wiring the system you must ensure the correct polarity. Normally the labelled wire is the ‘+’ lead and the
neutral wire is the ‘-’ lead. In principle with Canton loudspeakers the wide contact is the positive pole and the
narrow contact the negative pole. The polarity of the connectors of all separating filters is marked on the casing.
Wire We recommend high-grade wire with at least a 1.5 mm
2
cross-section. Remember that depending on where the
speakers are installed, you may need to bridge a considerable distance. Loudspeaker wires should never cross
edges or sharp body parts without suitable protection.
Installation Use the fittings and cable clips supplied to fasten and connect the loudspeakers.
Attention When installing and operating the loudspeakers please follow the safety regulations covering supporting body
parts, the road licensing regulations and the vehicle manufacturer’s instructions.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canton Car-Audio-Systems 2010-2012 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canton Car-Audio-Systems 2010-2012 in the language / languages: English, German as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info