34843
84
Zoom out
Zoom in
Previous page
1/100
Next page
Troubleshooting
80
Cannot Print Properly from the Digital Camera
The following are the possible errors that may occur when printing directly from a digital still
camera or digital video camcorder*, and the countermeasures to eliminate them.
*Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera.
*1
To resume printing, you can press the R
R
ESUME/CANCEL button on the printer instead of selecting C
C
ontinue.
Camera Error Message Possible Cause Try This
Printer in use Images are being printed from
the computer
Wait until printing ends. The printer automatically starts
printing the images from the camera after completing the
current printing.
Printer warming up The printer is warming up Wait until warm-up ends. When it is ready, the printer starts
printing automatically.
No paper No paper is loaded Load paper in either the Sheet Feeder or Cassette which you
have selected with the Paper Feed Switch on the printer, and
select C
C
ontinue
*1
in the display on your camera.
Paper error The Paper Output Tray is
closed
Open it to resume printing. If the Inner Cover is open, close it.
Paper jam A paper is jammed in the
printer
Select S
S
top in the display on your camera to stop printing.
Remove the jammed paper, load new paper, and press the
RESUME/CANCEL button on the printer and retry printing.
Printer cover open The Top Cover is open Close the Top Cover on the printer.
No print head The Print Head is defective or
not installed (The P
P
OWER
lamp on the printer flashes
five times.)
Install a Print Head according to the
Easy Setup Instructions
.
If the Print Head has already been installed, remove it to check
for any dirt or debris at its contacts. After cleaning, reinstall the
Print Head.
If the error still remains, the Print Head may be defective.
Contact the Customer Care Center.
Waste tank (ink absorber)
full
The waste ink absorber is
nearly full
The printer has a built-in waste ink absorber to hold the ink
used during print head cleaning. This error message indicates
that the waste ink absorber is nearly full.
You can continue printing for a while by selecting C
C
ontinue
*1
in
the display on your camera.
However, because printing is disabled once the waste ink
absorber becomes completely full, you are recommended to
contact the Customer Care Center as early as possible.
Ink is low It is about time to replace the
ink tank with a new one
Select C
C
ontinue
*1
in the display on your camera to resume
printing.
Ink tank is empty Replace the ink tank with a
new one
Printing resumes once the Top Cover is closed after ink tank
replacement.
You can continue printing by selecting C
C
ontinue
*1
in the display
on your camera with the ink tank empty. But, it is recommended
you replace it with a new one immediately after printing. It may
damage the printer if you continue printing with empty ink
tanks.
Printer error An error requiring servicing
might have occurred (the
POWER lamp on the printer
flashes alternately orange
and green).
Select S
S
top in the display on your camera to stop printing.
Disconnect the cable between the printer and the camera, turn
off the printer, and unplug the power cord of the printer from
the power supply. After a while, plug the power cord of the
printer back in, turn on the printer, and then reconnect the
camera to the printer.
If the same error occurs, contact the Customer Care Center.
84


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon Pixma IP 4000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon Pixma IP 4000 in the language / languages: English as an attachment in your email.

The manual is 5,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canon Pixma IP 4000

Canon Pixma IP 4000 Quick start guide - English - 32 pages

Canon Pixma IP 4000 User Manual - German - 215 pages

Canon Pixma IP 4000 User Manual - Dutch - 211 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info