709431
37
Zoom out
Zoom in
Previous page
1/56
Next page
3 System Connections Connecting the Cables
37
2. Place the ferrite core about 3 cm (1.2 in.) from the LAN
cables connector. Loop the cable once and close the ferrite
core.
Connecting the Power Supply and Network
1. Connect the 3-pin XLR connector of a commercially available AC adapter to the DC IN 24V terminal
on the camera head (9).
If using the robotic camera system outdoors, make sure to use a power connector certified for outdoor use and
make sure the power cable is plugged all the way in.
2. Connect the LAN cables connector with the ferrite core to the camera heads LAN (Ethernet) terminal,
and the other end of the LAN cable to an Ethernet hub (10).
3. Connect the control PC and, if necessary, the FTP server to the Ethernet hub.
Make sure to turn off the camera head before connecting/disconnecting a power source from the DC IN
24V terminal.
When using a PoE-compatible Ethernet hub, connect the LAN (Ethernet) terminal to a port without power
supply.
You can connect the control PC directly to the camera heads LAN (Ethernet) terminal, without using an
Ethernet hub. In such case, the control PC must be used also as the FTP server if you want to use the FTP
transfer function.
Turning the System On/Off
Set the camera heads power switch to the top position to turn on the camera head. The STATUS indicator will illuminate
in green. Set the power switch to the bottom position to turn off the camera head. The STATUS indicator will turn off.
Do not turn manually any rotating parts, as this will damage these parts. Always use the compatible
application or control device to operate the rotating parts.
Before turning on the camera head, make sure the lenss zoom is set to the wide-angle end.
Immediately after turning on the camera head and just before turning it off, make sure to perform the
homing procedure with the web setup tool. If the homing procedure is not performed, abnormal noises
may be produced near the motion range ends. Repeatedly skipping the homing procedure may cause
malfunctions.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon CR-S700R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon CR-S700R in the language / languages: English as an attachment in your email.

The manual is 5,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info