Manual Canadian Spa Company Swift Current (page 5 of 9) (English)

764872

Zoom out

Zoom in

1/9

Cleaning / Replacing Filter Cartridge

WARNING: RISK OF ELECTRIC SHOCK. Unplug the PCU

before beginning spa maintenance.

Note: A dirty ﬁlter cartridge may contaminate the spa water and

cause damage to the heating function.

1. Carefully thread the three plastic caps onto the inlet/outlet ports on inner spa wall.

(Ensure the rubber gaskets are in place within the plastic caps)

2. Unscrew ﬁlter housing lid by turning it counter-clockwise, then remove the ﬁlter

cartridge.

3. Rinse off ﬁlter cartridge with water and reuse if possible. Replace ﬁlter

if the cartridge remains dirty after rinsing or is badly discoloured.

4. Put the cleaned ﬁlter back into the cartridge housing and close the lid by

turning it clockwise.

5. Remove caps from inlet/outlet ports on inner spa wall and allow water to

ﬂow into pump. Tub is now ready for use.

Part 5 WATER MAINTENANCE

5. Install the Filter Cartridge

Open the Filter Housing lid counter-clockwise. Put the new ﬁlter cartridge into the cartridge

chamber and close the lid clockwise. Ensure black “O” ring is placed correctly inside housing.

6. Pre-Fill Check

Ensure the drain outlet is extended for future draining/access (Fig. A), check that the washer is

in the cap, then tighten. Check the stopper (Fig. B) on the bottom of the spa and the Drain Cap,

ensure both are closed tight. Fill the spa with water using a garden hose until reaching the

water level printed on both interior sides of the spa wall (Fig. C1 & C2). These lines are also used

as an indication of the levelness of the spa. PCU must be connected to the spa prior to ﬁlling.

7. Purge Air From Portable Control Unit

Turn on the PCU and select the ﬁlter function; the air in the pump must be released. Unscrew

the Air Valve counter-clockwise and release the air until the water is coming out, then screw

the air valve clockwise tightly. Use a towel to dry off the pump.

8. Thermal Blanket

Place Thermal Blanket on water surface for

more efﬁcient heating and improved heat

retention.

The ﬁlter cartridge should be cleaned weekly and replaced on a monthly basis, or depending on

use. A reminder will appear to change the ﬁlter after 25 days (‘CHG FIL’). Hold the ﬁlter button for 5

seconds to clear the message. Change water once a month or depending on use and use

appropriate spa chemicals. Please pay attention to the chemicals used and dosage. Spa damage

resulting from misuse of chemicals is not covered by the warranty.

Water Balance: We recommend you maintain your water balance: PH value: 7.2 - 7.6; Free

Chlorine: 2ppm - 3ppm. Use test kit to test your spa water before each use of the spa, or at least

once per week.

Water Sanitation: We suggest using chlorine or bromine granules to disinfect the spa’s water.

Never add tablets freely to spa water; a ﬂoating dispenser is recommended.

Cleaning the Spa: Clean the spa with soap and water, then rinse. Leave it outside (away from

direct sunlight) to dry.

Repairs: Small holes or punctures can be repaired with the repair kit that comes with the spa (glue

not included)

(1.) (2.) (3.)

MAINTENANCE / TROUBLE SHOOTING :

PROBLEM

Cloudy water

Odour

Eye skin/irritation

POSSIBLE CAUSE

High pH (test to verify)

Poor ﬁltration

High dissolved solids

High level of organic contaminants

Low pH and/or alkalinity

combined Chlorine due to organic

contamination

SOLUTION

Add pH down

Clean ﬁlter w/Filter Free

Empty spa and re-ﬁll

Increase the amount of Chlorine

Add Alkalinity Booster

Increase the amount of Chlorine

Granules

Part 4 USAGE

(Fig. A)

Press the Temperature Setting Button to set an appropriate temperature. Press the

Heating Button to heat the water. Put on the lid while heating. Once the water reaches the

desired temperature you can enjoy your spa. Press the Jet Massage Button to activate

massage system. We suggest a temperature range between 98.6°F-102°F (37-39℃)

during the winter. The massage system will stop automatically after 30 minutes of

operation to reduce energy consumption. Re-activate the Jet Massage function by

pressing the Jet Massage Button again (See Part 7 for Control Functions).

Lock the Buckle

Push the square pad upwards to lock and downwards to unlock (Fig. A).

(Fig. A) (Fig. C1) (Fig. C2)

(Fig. B)

‘O’Ring Gasket

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Canadian Spa Company Swift Current in the language / languages: English as an attachment in your email.

The manual is 7,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canadian Spa Company Swift Current

Canadian Spa Company Swift Current User Manual - German - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Canadian Spa Company Swift Current Manual

Product: