662455

Campingaz Shashlik Rotario Manual

13
Zoom out
Zoom in
Previous page
1/56
Next page
- 13 -
Consumption: 182 g/h (2.5 kW) - injector n° 48
Category: butane direct pressure
Thank you for choosing this Campingaz
®
Shashlik
Rotario camping stove.
Figures: see pages 2 to 8.
A - IMPORTANT: YOU ARE USING GAS, BE
VERY CAREFUL!
The purpose of these instructions is to enable you
to use your Campingaz
®
appliance correctly and in
complete safety.
Please read them carefully to familiarise yourself
with the equipment prior to assembling the gas
container. Keep these instructions in a safe place so
that you can refer to them if needed.
Please observe these instructions and the safety
measures printed on the Campingaz
®
CV 470 PLUS
cartridges. Failure to observe these instructions
may result in the user and people in the immediate
vicinity being put at risk.
This equipment must be used exclusively with
Campingaz
®
CV 470 PLUS cartridges. Using other
gas containers may be dangerous.
The Société Application Des Gaz accepts no
responsibility where cartridges of any other make
are used.
This equipment should only be used outside
premises and kept away from inflammable materials.
Do not use equipment which leaks, functions
incorrectly or is damaged. Return it to your retailer
who will inform you of your nearest after-sales
service.
WARNING: accessible parts may be very hot. Keep
young children away from the device.
Never modify this equipment or use it for purposes
for which it is not intended.
Do not use this product in caravans, cars, tents,
huts, sheds or any small enclosed areas.
The product should not be used while sleeping or
left unattended.
This product consumes fuel through combustion or
consumption of oxygen and gives off certain
substances and gas, which could be dangerous
such as carbon monoxide.
Carbon monoxide is an odorless, clear gas that can
cause flu-like symptoms, sickness, illness, and
possibly death if produced inside aforesaid
enclosed areas through use of the product without
proper ventilation.
B – PREPARING THE DEVICE
- Open and unfold the two feet (1) (fig. 1) and the hook
(16) located on top of the device.
- Lie the device in a horizontal position and fully raise
the two hooks (2) located at the rear of the device to a
vertical position (fig. 2).
- Carefully open the device until you hear a click (fig. 3),
then push the two locking hooks (2) down.
- Take the drippings tray (3) and the five spits (4) out of
the device (fig. 4).
- Remove the spring (5) that keeps the spit holder in
place (6) by unfastening the hooks located on each
end of the spring (fig. 5). Put the spring in a place
where it will be easy to find.
- Remove the spit holder frame (6) from the burner cage
(7) by pulling it out (fig. 6).
- Place the spit holder frame (6) inside the burner cage
(7) by aligning the “C” hooks and the lower “B” stops
with the tabs located on each side of the burner cage
(fig. 7). Ensure that the frame is snugly attached to the
burner cage.
- Remove the spit motor (8) positioned behind the
device by detaching the adhesive band (fig. 8).
- Inserting a battery in the spit motor: The motor
operates on a Type D (LR20) 1.5 V battery. Unscrew
the battery housing in the direction indicated in figure 9
after carefully removing the protective plastic sleeve.
- Place the battery inside the housing in the direction
indicated in figure 9, then reposition the housing by
aligning the slots in the housing with the tabs on the
motor following the “A” axis – see figure 9.
- Put the protective plastic sleeve back in place on the
motor to ensure that the motor is watertight in case of
rain or the presence of moisture.
- Check that the motor is working by activating the red
motor button (two rotational directions).
- Put the spit motor (8) in place as indicated in figure 9.
Be sure that the motor hole coincides with the
corresponding hole in the spit holder frame.
- Inserting spits (4) on the spit holder frame (6) (fig.
10): The spits must be inserted starting at the bottom
(spit motor). Hold a spit by placing your middle and
index fingers in the “a” area, then push on the “b”
handle with your thumb (fig. 10). Keep pushing as you
thread the spit in the hole located on the motor side,
then place it in the slot located on the other side. Stop
pushing on the “b” handle. The toothed wheel should
be on the outside of the frame.
Inserting the lower spit: To insert the spit in the motor
hole (8) (fig. 10), raise the motor slightly and insert the
spit in the hole.
- When all the spits are in place, turn on the motor (8) to
check that the spits turn properly (fig. 11). The five
spits should turn together.
- Insert the drippings tray (3) (fig. 11).
- Remove the regulator (9) from its housing by pulling
firmly (fig. 12) and insert a Campingaz
®
CV 470 Plus
gas cylinder (see the paragraph below on INSERTING
A CAMPINGAZ
®
CV 470 PLUS CYLINDER).
- When the gas cylinder has been connected to the
regulator, hang the regulator-cylinder unit on the
device as shown in figure 14.
INSTALLING THE CAMPINGAZ
®
CV 470 PLUS
CARTRIDGE
Where the existing cartridge is empty, read paragraph D:
"Changing the cartridge").
When installing or changing a cartridge, always operate
in a very well-ventilated location, preferably outside,
never near a flame, heat source or spark (cigarette,
electric apparatus, etc.) and far away from other people
and inflammable materials.
GB
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Campingaz Shashlik Rotario at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Campingaz Shashlik Rotario in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Finnish, Norwegian, Finnish as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info