662455
15
Zoom out
Zoom in
Previous page
1/56
Next page
- 15 -
Turning off the device
When cooking is finished, turn the adjustment wheel (10)
all the way in a clockwise direction (toward the end
of the arrow) (fig. 13).
D – CHANGING THE CARTRIDGE
REMINDER
Always insert or remove cartridges in a very well
ventilated area, where there are no flames, heat
sources or sparks (cigarettes, electrical appliances,
cookers, etc.), and well away from other people and
inflammable material. Whenever possible change
the cartridge outside.
The cartridge may be removed even if it is not
empty. Replace the cartridge outside and away from
other people.
- Wait until the device has cooled.
- Check that the gas feed is properly closed by turning
the adjustment wheel (10) all the way in a clockwise
direction (toward the end of the arrow) (fig. 17);
check that the stove (12) has been turned off before
removing the gas container.
- Unhook the regulator-cylinder unit from its point of
attachment by lifting it up (fig. 16). Do not pull it toward
you; you may damage the unit holder.
- Holding the regulator (9), unscrew the cylinder (11) by
turning it in the direction indicated in figure 17 and
remove it.
- Insert a new cylinder according to the instructions
given in the “INSERTING A CAMPINGAZ
®
CV470
PLUS CYLINDER paragraph.
- Put the regulator-cylinder unit back in place (fig. 14).
Caution:
When changing a cylinder during use, do not touch
the hot surfaces on the device (stove, spit holder
frame, etc.).
Never throw away a cartridge which is not completely
empty, (check there is no liquid in the cartridge by
shaking it).
E – DISASSEMBLY, UPKEEP AND
STORAGE
If you take regular care of your device, it will give you
satisfaction for many years.
Do not clean your device while it is in use. Wait until it
has cooled to avoid being burned by hot parts (drippings
tray, spit holder frame).
Once your equipment has fully cooled:
1 - Storage
- Check that the gas feed is properly closed by turning
the adjustment wheel (10) all the way in a clockwise
direction (toward the end of the arrow) (fig. 17);
check that the stove (12) is turned off.
- Disconnect the gas cylinder (11) from the regulator (9)
(see the paragraph on CHANGING THE CYLINDER),
then place the regulator in its storage housing behind
the device (fig. 18).
- Remove the spit motor (8) and place it in its storage
housing behind the device (fig. 21). Fasten it in place
by putting the adhesive band around it.
- Remove the spit holder frame (6) from the burner cage
(7) by pulling it up slightly to free the tabs, then store it
inside the burner cage by positioning the “C” hooks
and B” stops in the vertical slots at the bottom of the
cage (fig. 19).
- Put the spring (5) back in place by attaching the hooks
at the top and bottom of the burner cage and on top of
the spit holder frame (fig. 20).
- Store the spits (4) in the lower part (fig. 22), then place
the drippings tray (3) upside down on top of them.
- Disconnect the two hooks (2) located at the bottom of
and behind the device. Squeeze them to unlock them
(fig. 23).
- Push the red locking button (15) located behind the
device to the right, then carefully close the device (fig.
24).
- Lock the device:
o Reposition the two hooks (2) at the rear of the
device,
o Raise the hook (16) located on top of the device (fig.
25),
o Fold the feet inside their housing.
Your device is now ready for storing or transporting.
Store the equipment and the cartridge in a cool, dry and
well-ventilated area, out of reach of children. Never store
in a basement or cellar.
If you will not be using the device for a long period of
time, disconnect the cylinder from the device by
proceeding as indicated in paragraph D.
In the case of the injector becoming clogged (the
cylinder still contains gas but the equipment will not
light), do not try to unclog it yourself. Return the
equipment to your retailer.
2 – Cleaning
Body of the device
Clean the device after having removed the gas
cylinder (see paragraph D).
Clean the drippings tray (3), the spits (4), the spit
holder (6) and the internal parts of the device with a
gentle, non-abrasive cleanser, such as dishwashing
detergent, and hot water. Dry with a cloth. Note:
These elements may be washed in a dishwasher.
Ceramic burner parts (12)
The ceramic parts are the active burner components;
they glow when in use. Do not clean or rub them or get
them wet, since this could cause damage.
GB
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Campingaz Shashlik Rotario at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Campingaz Shashlik Rotario in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Finnish, Norwegian, Finnish as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info