662185

Campingaz 2 Series RBS L Manual

10
Zoom out
Zoom in
Previous page
1/88
Next page
10
GB
Handle the lid carefully, especially during operation. Do not
lean over the base.
F. CHECKING FOR GAS LEAKS
Important: Never use a naked flame to check for gas leaks.
1. Work outside, away from all sources of ignition. Do not
smoke.
2. Make sure the control knobs are in the “off” (O) position.
3. Connect the flexible hose to the connector and appliance as
described in Section D.
4. Fit the regulator onto the gas cylinder in accordance with its
instructions.
5. Use a gas leak solution to test for leaks.
6. (Fig. 5 A) Apply the solution to the connections cylinder/
regulator/hose/appliance.
7. Open the gas cylinder valve (the control knobs should
remain closed: off position (O)). Bubbles in the gas leak
solution indicate that there is a gas leak.
8. The leak can be stopped by tightening any hose connection
or replacing any faulty component. The appliance must not
be used until the leak is stopped.
9. Close the valve on the gas cylinder.
Important:
Check for leaks at least once per year and each time the gas
cylinder is replaced.
G. PRIOR TO USE
Never use the appliance until the instructions have been read
carefully and understood. Additionally, ensure that:
y There are no leaks.
y (Fig. 6) The venturi tubes (VT) are not blocked (example:
Cobwebs)
y (Fig. 5 B) The hose does not touch any components which
may get hot.
y The ventilation openings in the cylinder storing compartment
(if present) are not obstructed.
y The grease trap(s) is (are) correctly inserted into its (their)
compartment and that it (they) is (are) correctly positioned,
as far as it (they) will go.
y The heat reflector is correctly installed at the bottom of the
firebox.
y The firebox’s 6 removable parts are reinserted (see Section
O Cleaning and maintenance).
H. LIGHTING THE BARBECUE BURNERS
Never light the appliance with the lid closed, only with the lid
opened.
1. (Fig. 7 A) Open the cooking lid.
2. (Fig. 7 B) Make sure that the control knobs are in the “OFF”
position (O).
3. Open the gas cylinder valve.
4. (Fig. 8 A) Push and turn the control knob of the desired
burner counterclockwise to position (
). Press the
ignition button (
).
5. If your barbecue is equipped with a piezoelectric
igniter:
y (Fig. 8 B) Press immediately on the igniter button (
)
until it clicks.
y If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
6. If your barbecue is equipped with an electronic spark
igniter:
y (Fig. 8 B) Press immediately on the switch (
). A burst
of sparks occurs. Continue pressing for a few seconds
until the burner is lit.
y If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
7. Adjust the flame to the desired height by turning the control
knob between (
) and ( ).
8. Do the same for all the burners.
9. If the electronic ignition system does not work, light the
barbecue manually (next paragraph).
I. LIGHTING THE BARBECUE MANUALLY
1. Open the cooking lid.
2. Make sure that the control knobs are in the “OFF” position
(O).
3. Remove one of the cooking grids to gain access to the
burners.
4. Turn on the gas supply (valve or lever on the regulator).
5. (Fig. 8 C) Put a lighted match in front of the burner.
6. (Fig. 8 A) Push and turn the control knob to the desired
burner counterclockwise to position (
).
7. Adjust the flame to the desired height by turning the control
knob between (
) and ( ).
Once the burner is lit, replace the grid or griddle.
J. EXTINGUISHING THE BARBECUE
(Fig. 7 B) Return the control knobs to the “off” position (O), then
close the cylinder valve.
K. LIGHTING THE SIDE BURNER
(DEPENDING ON THE MODEL)
The side burner may operate independently or in conjunction
with the barbecue burner. Before igniting the side burner, be
sure that the lid is opened and then tucked away (Fig. 9A, B).
Lighting:
1. Open the gas cylinder valve.
2. (Fig. 5 A)Check that there is no gas leak between the gas
cylinder and the side burner.
3. Check the condition of the hose connecting the grill burner
to the side burner. If there are signs of cracks, call our after
sales service to have it replaced.
4. (Fig. 9 C) Press and rotate the control knob on the side
burner (
) to its FULL FLOW position ( ).
5. (Fig. 9 D) Press the ignition button (
) until the burner lights.
If the burner does not light after 10 seconds, put a match to
the edge of the burner.
6. Adjust the flame to the dimensions of the recipient by using
the two flow positions: HIGH (
) or LOW ( ). Do not
use recipients with a diameter less than 10 cm or over 24
cm.
L. TURNING OFF THE SIDE BURNER
(DEPENDING ON THE MODEL)
Return the control knob ( ) to the OFF (O) position, then
close the valve on the gas cylinder if the appliance is not in use.
To close the lid, slide it in its grooves, pulling it upwards until it
reaches the spindle, then tip it forwards.
M. REPLACING THE GAS CYLINDER
1. Always work in a well ventilated area and never in the
presence of a flame, spark or heat source.
2. Return the control knobs to the “off” position (O) (Fig. 7 B)
then close the cylinder valve.
3. Remove the regulator, check that the sealing joint is in good
condition.
4. Put the full cylinder in place, refit the regulator, taking care
not to apply stress to the hose.
5. Check for gas leaks according to Section F.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Campingaz 2 Series RBS L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Campingaz 2 Series RBS L in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Portuguese, Spanish as an attachment in your email.

The manual is 8,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info