631286
26
Zoom out
Zoom in
Previous page
1/68
Next page
17
7
7
1
2
3
4
Drawing Up Lower (bobbin) Thread
1. Raise the presser foot and the needle to their highest positions.
2. With your left hand, hold the end of the upper thread. With
your right hand, turn the balance wheel toward you
(counterclockwise) until the needle moves down and back up
again to its highest position.
3. The upper thread should have caught the lower thread in a
loop. Pull the upper thread toward you and the lower thread
will come up from the bobbin in a large loop.
4. Pull out about 15 cm (6") of both threads and place them
toward the back of the machine straight behind the presser
foot. The upper thread should pass between the toes of the
presser foot.
a Upper thread
b Lower thread loop
c Lower thread
Remontée du fil inférieur (canette)
1. Lever au maximum le pied-de-biche et l’aiguille.
2. Avec la main gauche, tenir l’extrémité du fil supérieur. Avec
la main droite, tourner le volant vers soi (dans le sens
contraire aux aiguilles d’une montre) jusqu’à ce que l’aiguille
descende puis remonte à nouveau complètement.
3. Le fil supérieur doit alors former une boucle avec le fil
inférieur. Tirer vers soi le fil supérieur: le fil inférieur va se
dérouler de la canette et former une boucle de plus en plus
large.
4. Tirer environ 15 cm de chacun des deux fils et les placer vers
l’arrière de la machine, juste derrière le pied-de-biche. Le fil
supérieur doit passer entre les branches du pied-de-biche.
a Fil supérieur
b Boucle du fil inférieur
c Fil inférieur
Para sacar el hilo de la canilla
1. Levante el prensatelas y la aguja a sus posiciones más elevadas.
2. Con la mano izquierda, sujete el extremo del hilo superior. Con la
mano derecha, gire la ruedecilla hacia usted (en el sentido
contrario al de las manecillas de un reloj) hasta que la aguja vaya
hacia abajo y suba a su posición más alta.
3. El hilo superior debe haber enganchado el hilo inferior y hacer
una lazada. Tire del hilo superior hacia usted y el hilo inferior
saldrá de la canilla en una baga larga.
4. Tire unos 15 cm (6") de ambos hilos y colóquelos hacia la parte
atrás de la máquina, justo detrás del prensatelas. El hilo superior
debe pasar entre los salientes del prensatelas.
a Hilo superior
b Bagas en el hilo inferior
c Hilo inferior
Вытягивание нижней (шпульной) нити
1. Поднимите прижимную лапку и иглу в крайнее верхнее
положение.
2. Левой рукой удерживайте конец верхней нити. Правой
рукой вращайте маховик по направлению к себе (против
часовой стрелки), пока игла не опустится вниз и вновь не
займет крайнее верхнее положение.
3. Верхняя нить должна захватить нижнюю нить в петлю.
Потяните верхнюю нить на себя, и нижняя нить вытянется
из шпульки в виде большой петли.
4. Вытяните порядка 15 см обеих нитей и разместите их
прямолинейно по направлению к задней части машины за
прижимной лапкой. Верхнюю нить следует пропустить в
прорезь в прижимной лапке.
a Верхняя нить
b Петля нижней нити
c Нижняя нить
E
CB
A
D
5
6
8
1
2
1
3
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother LS-3125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother LS-3125 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 9,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info