780273
19
Zoom out
Zoom in
Previous page
1/26
Next page
19
Error Code Description Solution
10 The battery voltage is too low Charge the battery pack with the battery charger.
11 The battery voltage is too high
Switch the system completely off and on again using the T4
key on the control unit. If the problem persists, contact your
e-bike dealer.
12 The battery is almost completely discharged Charge the battery pack with the battery charger.
20 Electrical measurements are erroneous Switch the system completely off and on again using the
LED key (28) on the battery pack (26). If the problem per-
sists, contact your e-bike dealer.
21 Thermocouple defective
24 The internal voltage is beyond the operating range Charge the battery pack with the battery charger.
25 Error in the motor current measurement Switch the system completely off and on again using the T4
key on the control unit. If the problem persists, contact your
e-bike dealer.
26 A software reset has been performed
40/41 Detection of overcurrent in the motor Reduce the load on the motor by pedaling less or reducing
the support level.
42 Fault in the engine rotation Switch the system completely off and on again using the T4
key on the control unit. If the problem persists, contact your
e-bike dealer.
43 Short-circuit in the motor
44 Overheating of the motor Reduce the load on the motor by pedaling less or reducing
the support level.
45 The software has corrected an error when turning
the motor Switch the system completely off and on again using the T4
key on the control unit. If the problem persists, contact your
e-bike dealer.
46 No motor movement detected although a current
> 2 A was measured
60 Interruption of data exchange on the CAN-BUS Check the cables and plug connections of all components
of the e-Bike system.
70 Force on the pedal is not within the valid range
Switch the system completely off and on again using the T4
key on the control unit. If the problem persists, contact your
e-bike dealer.
71 Pedal rotation is not detected
72 Force on the pedal is not detected
73 Connection to pedal force sensor is faulty
74 Errors were detected in the data
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brose Bristol E-Touring at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brose Bristol E-Touring in the language / languages: English as an attachment in your email.

The manual is 0.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info