504591

Brita 3-Way Water Filter Dispenser Manual

5
Zoom out
Zoom in
Previous page
1/13
Next page
4 ENGLISH
c To switch from 90 days to 180 days, press the DISPLAY button
briefl y.
d Wait until the indicator stops fl ashing or the DISPLAY switches
off.
e To activate the 180-day timer, briefl y press DISPLAY and then
press the START/RESET button.
f A fl ashing spot in the bottom left of the display indicates that
the timer has begun.
C Reading actual status
To activate the display during operation, press the DISPLAY button
briefl y. The remaining time since the new cartridge was inserted is
shown in days. If the time is exceeded, the time is displayed with
a minus sign.
D Audible signals
a Signal to replace the cartridge: A long signal sounds on the hour
every hour when there are less than 10 days before the end
of the programmed 90 or 180 day setting (15 double beeps). A
shorter reminder (5 double beeps) then sounds every 15 minutes
until the next signal.
b Reminder function: Press any button to deactivate the signal for
72 hours if you prefer to be reminded to replace the cartridge at
a later date.
c Battery change signal: When the batteries are depleted, a long
signal sounds (15 single beeps) followed by a short reminder
signal (5 single beeps) every 15 minutes until the next signal on
the hour.
d Switching the device off: This is only possible by removing the
batteries from the battery compartment.
E Activating the reset function when replacing the
cartridge
a Press the DISPLAY button briefl y to activate the display.
b Press and hold the START/RESET button for 5 seconds until a
long beep sounds.
c The last programmed 90 or 180 day setting now appears in the
display.
d The timer starts automatically.
F Changing the batteries
a After changing the batteries, a long beep sounds.
b After the beep, press the DISPLAY button briefl y to activate the
display.
c The remaining days since the last reset are now displayed.
(Caution: Only possible up to 16 hours after the batteries are
fully depleted. After this time, the device reverts back to the
factory setting and must be reprogrammed – see Point B).
G Installation
You can fi x the electronic BRITA cartridge exchange indicator with
display to a suitable, dry place using the supplied hook and loop
fastener. We recommend installing it under the sink. Avoid contact
with water/splashes!
H Reprogramming the BRITA cartridge
exchange indicator
a Press the DISPLAY button briefl y to activate the display.
The preprogrammed 90 or 180 day setting is displayed.
b Press and hold the DISPLAY button and then press the
START/RESET button briefl y at the same time. This activates
the setting mode.
c To switch to 90 or 180 or 360 days, press the DISPLAY button
briefl y (360 days for +-setting for P 3000 refi ll cartridge).
d Wait until the selected value stops fl ashing or the DISPLAY
switches off.
e To activate the selected timer, press the DISPLAY button briefl y
and then press the START/RESET button.
Technical data:
• Batteries: 2 AA (removable)
• Acoustic alarm: when batteries are low, or after 3 or 6 months
• To avoid loss of data, change the battery within 12 hours.
• After 16 hours without power, the appliance switches back to its
factory settings.
• The display automatically switches to stand-by mode after 10
seconds.
(fi g. 4)
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brita 3-Way Water Filter Dispenser at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brita 3-Way Water Filter Dispenser in the language / languages: English as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info