562822

BrightSign 4K242 Manual

22
Zoom out
Zoom in
Previous page
1/26
Next page
BrightSign 4K242, 4K1042, 4K1142
19
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2014
from the NAND flash device into the SDRAM and then execute the code from the SDRAM. The SDRAM runs at a clock
rate of 1067MHz, with a data rate of 2133MT/s.
Serial Port
The 4K1042 and 4K1142 have a built-in UART that communicates with the RS-232 level shifter. The MAX232 creates
valid RS-232 voltage levels for the transmit pin by using a capacitive voltage switcher.
Audio Outputs
BrightSign 4K players each have a single high quality audio DAC device, which takes in digital audio signals from the
CPU in an I2S audio format. The AUD_LRCIN is the framing signal for the audio and runs at the frame rate of the audio
source (usually either 44.1KHz or 48KHz). The AUD_BITCLK signal is typically 32 times higher than the AUD_LRCIN.
The audio output is fed through an amplifier and sent directly to the audio output jack. It can drive a 32Ω load with a 2V
RMS signal.
On-Board LEDs
There are eight on-board LEDs that indicate the following:
LED Indication
Green power (Pwr)
Displays when the board is powered up and not in reset mode.
Green file-system activity
(Bsy)
Flashes any time there is file-system activity (on any storage device)
Green MicroSD activity
(µSD)
Displays when a MicroSD card is present.
Green network activity (Svr)
Displays when the player is connected to the BrightSign Network.
Green Ethernet activity (Eth)
Flashes when the player is connecting to the network. Displays when connected.
Green WiFi activity Flashes when the player is connecting to the wireless network. Displays when connected.
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BrightSign 4K242 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BrightSign 4K242 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info