562822
23
Zoom out
Zoom in
Previous page
1/26
Next page
BrightSign 4K242, 4K1042, 4K1142
20
All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to
change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2014
Yellow update (Upd)
Flashes when the board is being upgraded.
Red status (Err)
Flashes a certain number of times to indicate which error is occurring. The flash codes are
described below.
2 Unspecified error
3 Network recovery script is preparing to run on a device configured for network recovery.
4 No upgrade file found
5 Failed to load kernel module
6 Board is not capable of running the current firmware version.
7 A piece of on-board hardware is not working.
8 Problem related to the storage device (either the USB drive or SD card)
9 Problem related to the registry/NAND
10 The autorun script encountered a load/run error.
11 WiFi-related error (mainly, WiFi not found on USB)
12 Unable to find a bootable image
On-Board Switch
The on-board switch is connected to the GPIO02. A pull-up on the button normally sets the GPIO02 to be pulled high.
Conversely, the GPIO02 is pulled low when the service (SVC) button is pressed.
Reset Switch/GPIO Button
The on-board switch is connected to the reset circuit. Pressing down the reset button will cause the GPIO07 to go low.
Holding the reset button low for approximately 10 seconds will cause a hard reset. When the board goes into reset mode,
the power LED will be dark until the reset button is released.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BrightSign 4K242 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BrightSign 4K242 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info