Manual BrightSign 4K242 (page 21 of 26) (English)

562822

Zoom out

Zoom in

1/26

BrightSign 4K242, 4K1042, 4K1142

All information provided in this reference manual applies to products under development. The characteristics and specifications of these products are subject to

change without notice. BrightSign assumes no obligation regarding future manufacturing unless otherwise agreed to in writing. © BrightSign LLC, 2014

THEORY OF OPERATION

This section describes how different components operate on BrightSign 4K players.

Power Supply

There are several voltage levels present in BrightSign 4K players.

Reset

BrightSign 4K players have a Low Voltage Reset circuit. This circuit will hold the RESET_L signal low until a valid 3.3V

power source is present.

BCM7444/7252 CPU

The 4K242 and 4K1042 utilize a BCM7252 CPU, while the 4K1142 utilizes a BCM7444 CPU. The CPU is reset by the

RESET_L signal from the low voltage reset circuit going into the RESET_IN pin on the CPU. When the RESET_IN pin

goes from low to high, the CPU will boot from the NAND flash.

Built-in Flash

The boot code in the BCM7252/BCM7444 instructs it to continue the boot process by reading additional code from the

onboard NAND flash, which can be updated in the field, either from a SDHC/SDXC flash card or a USB mass-storage

device. Part of the NAND flash is also used to hold non-volatile parameters. The contents of the boot flash are copied into

the SDRAM. The CPU then jumps to the boot code.

SDRAM

The 4K1142 contains six banks of DDR SDRAM (two 4GB banks and four 2GB banks), while the 4K242 and 4K1042

each contain four banks of DDR SDRAM (two 2GB banks and two 4GB banks). When the CPU boots, it will copy the code

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BrightSign 4K242 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BrightSign 4K242 Manual

Product: