Manual Brevi Tazio TT (page 15 of 72) (English, German, French, Italian, Portuguese, Spanish)

768834

Zoom out

Zoom in

1/72

4. Pull the vehicle belt 22 out and guide it through the belt guides

of the child seat. Make sure that the belt is not twisted (g. F20)

5. Engage the buckle tongue in the vehicle seat buckle 29 this

should make a click noise (g. F21)

6. On the side opposite the car seat belt buckle, swivel clamping

lever 24 and insert diagonal belt in belt lock-off 25 (g. F22)

7. Apply your body weight to the child seat (kneel into the seat). At

the same time pull the diagonal belt strongly to tighten

8. Follow the steps in section securing your child with 5-point

harness

For the safety of your child, before every journey in the car check that:

• the child seat is rmly installed in the vehicle

• the belt is not twisted

• the diagonal belt is only clamped by the lock-off 24 which is

located on the opposite side from the car seat belt buckle 29 (g.

F21, F22)

• the straps of the child safety seat are close to the body without

constricting the child

• the shoulder belts 08 are correctly adjusted and the straps are

not twisted

• the shoulder pads 19 are at the same level as your child’s shoul-

ders (g. F3)

• the buckle latches 20 are engaged in the harness buckle 21

(g. F16)

4.3 Group 2 (15-25 kg) vehicle belt+ top tether

+5-point harness

1.Follow the steps in section 4.2 (to x child seat by three point

belt.)

2.Take the top tether and if required, lengthen the belt by pressing

the top tether brake button to release the strap, pulling to adjust

as necessary (g. F11).

3.Hook the snap hook 17 into the Top Tether anchoring point re-

commended in your vehicle owner guide. Look for this symbol in

your vehicle (g. F12).

4.To tension the top tether, remove any slack by pulling on the

free end of strap until it is suitably tightened. The top tether will

be properly tightened when the tension indicator turns completely

green (g. F13).

5.Follow the steps in section securing your child with 5-point harness

For the safety of your child, before every journey in the car check

that:

• the child seat is rmly installed in the vehicle

• the belt is not twisted

• the Top Tether (g. F13) is tightly tensioned over the backrest of

the car seat and the tension indicator is green

• the diagonal belt is only clamped by the lock-off 24 which is

located on the opposite side from the car seat belt buckle 29 (g.

F21, F22)

• the straps of the child safety seat are close to the body without

constricting the child

• the shoulder belts 08 are correctly adjusted and the straps are

not twisted

• the shoulder pads 19 are at the same level as your child’s shoul-

ders (g. F3)

• the buckle latches 20 are engaged in the harness buckle 21

(g. F16)

4.4 Group 2 (15-25 kg) & group 3 (22-36 kg) vehicle

belt

1. Make sure that the child seats 5-point harness is removed cor-

rectly (see section 6)

2. Follow the steps in section 3.3 (to adjust headrest.)

3. Follow the steps in section 4.1 , install child seat with ISOFIX

and top tether (option).

TIP

For group 2 and 3 the ISOFix connectors and top tether have

been designed to improve stability. In case of problem during use

in your vehicle , it is possible to use without this option.

4. Have your child sit down in the child seat.

5. Pull out the vehicle seat belt and guide it in front of your child

to the vehicle seat buckle 29 . Engage the buckle tongue in the

vehicle seat buckle 29 CLICK! (g. F26, F27)

CAUTION! Do not twist the belt.

6. Place the diagonal seat belt section 11 and lap belt section 28

on the side of the vehicle seat belt buckle 29 under the armrest

and into the red belt guide 23 of the child seat (g. F27, F28).

7. Place the lap belt section 28 on the other side of the child seat

in the red belt guide 23 (g. F28).

8. Guide the diagonal seat belt section 11 into the red belt holder

30 of the headrest 07 until it lies completely in the belt holder 30

and is not twisted (g. F29).

9. Make sure that the diagonal seat belt section 11 runs over your

child shoulder bone, and not in front of his or her neck.

TIP

You can still adjust the height of the headrest 07 again here in

the vehicle.

For the safety of your child, before every journey in the car check

that:

• the lap belt section 28 runs through the light red belt guides 23

on both sides of the seat cushion

• the diagonal seat belt section 11 on the side of the vehicle seat

belt buckle 29 also runs through the light red belt guide 23 of the

seat cushion

• the diagonal seat belt section 11 runs through the dark red belt

holder 30 of the headrest

5. REMOVAL OF THE CHILD SEAT

1.To release the ISOFIX fastening, squeeze the safety buttons,

rst on one side, then on the other (g. F8).

2.Open the buckle of the vehicle seat belt and pull out the diago-

nal from lock-off.

3.To release the Top Tether anchoring, loosen the belt by pressing

the brake button of the adjuster. Then take the spring hook out of

the anchoring point.

4.Slide the ISOFIX locking arms back into the seat shell .

6.REMOVING THE 5-POINT HARNESS

1. Loosen the 5-point harness of the child seat as much as pos-

sible (g. F30).

Back side of the child seat:

534-01-161124-00 ISTRUZIONI SEGGIOLINO AUTO TAZIO TT.indd 15 30/11/2016 15.29.41

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Brevi Tazio TT in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 11,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Brevi Tazio TT Manual

Product: