697430
25
Zoom out
Zoom in
Previous page
1/48
Next page
Control unit
25
Uni Condens 8000 F – 6720867056 (2016/10)
7 Control unit
DANGER:
Danger to life and of system damage through faulty connections.
Only carry out electrical work if you are properly qualified.
Observe the local installation regulations.
The system installer must issue a wiring diagram which records the
interfaces between heating output elements, burner, control unit
(CFB/CC) and additional safety equipment.
Make sure that the electrical installations are suitable for wet areas.
DANGER:
Danger to life due to electric shock!
Before opening the control unit or boiler, isolate the heating system
across all poles and secure against unintentional reconnection.
Carefully route the cables/leads and capillary tubes.
Ensure that the capillaries are never kinked.
Create a permanent connection in accordance with the applicable
international installation standards and local regulations.
7.1 Requirements for the control unit
We recommend using a control unit from the CFB 800/CFB 900 or
CC 8000 series.
The purpose of optimum control unit settings is to achieve long burner
runtimes and avoid rapid temperature changes in the boiler. Gentle
temperature changes result in a longer service life of the heating system.
The control strategy of the control unit must therefore be prevented from
becoming ineffective, i.e. through the boiler temperature controller
switching the burner on and off.
Observe the following points when selecting the control unit.
The control unit must ensure that the maximum internal boiler water
temperature and the high limit safety cut-out are at least 5 K apart.
It must also be ensured that the control electronics rather than the
boiler temperature controller switch the burner on and off.
The control unit must ensure that the burner is switched to low load
before a controlled shutdown. If this is not observed, the safety shut-
off valve (SAV) in the gas train may lock out.
Select and adjust the control unit so as to allow a gentle start-up of
the boiler with a time delay when the system is cold. The heat energy
demand must only be switched on with time delay.
After the burner demand, an automatic timer (for example) should
limit the burner to low load for a period of approx. 150 seconds. A
restricted heat demand will prevent uncontrolled starting and
stopping of the burner.
It must be possible to show the number of burner starts at the control
unit used (or alternatively at the burner control unit).
The maximum number of burner starts must be monitored. There
should be a maximum of 6 burner starts per hour (averaged over
burner runtime on one day). If the number of starts is higher, the user
should be notified. The system must be checked to find out whether
the number of burner starts can be reduced. The customer service of
the manufacturer can provide assistance with optimisation of the
system.
Maintain the minimum differential between the selected shutdown
temperature of the high limit safety cut-out, the temperature
controller, the maximum boiler temperature and the maximum
temperature demand ( CFB 800/CFB 900: tab. 12, page 27;
CC 8000: tab. 14, page 31).
The maximum boiler temperature can be selected in the user interface of
the control unit in the “Boiler parameters” menu, under the menu item
“Max. shutdown temperature”.
Select set temperatures for the heating circuits that are as low as
possible.
Start heating circuits at 5 minute intervals (e.g. when starting up
in the mornings).
7.2 Control unit of CFB 800/CFB 900 series
(accessories)
The position of the terminal strip in control units of the CFB 800/CFB
900 series varies, depending on the control unit, but the labelling of the
terminal strips is identical. The terminal strip is easy to identify after the
control unit has been opened.
You can use the following control units with the boiler:
CFB 840
CFB 810
CFB 810
CFB 830
The control unit can be fitted either on top of the boiler or, with the
control unit holder (accessory), onto the boiler side.
When using the side-mounted control unit holder:
Observe the attached installation instructions.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch Uni Condens 8000 F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch Uni Condens 8000 F in the language / languages: English as an attachment in your email.

The manual is 10,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bosch Uni Condens 8000 F

Bosch Uni Condens 8000 F User Manual - English - 12 pages

Bosch Uni Condens 8000 F User Manual - German - 16 pages

Bosch Uni Condens 8000 F User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info