544063

Bosch PPR 250 Manual

17
Zoom out
Zoom in
Previous page
1/184
Next page
English | 17
Bosch Power Tools 2 609 006 717 | (26.11.13)
Technical Data
Noise Information
Typically the A-weighted sound pressure level of the product
is less than 70 dB(A).
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under “Technical Data” is in conformity with the fol-
lowing standards or standardization documents: EN 60335,
EN 300 220-1:2006, EN 300 220-2:2007, EN 301 489-
1:2008, EN 301 489-3:2002 according to the provisions of
the directives 2011/65/EU, 2006/95/EC, 2004/108/EC,
1999/5/EC.
11
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 26.11.2013
Assembly
Before any work on the machine itself, pull the mains
plug.
Unreel the Feed Hose (see figure A)
–Open holding clamp 21 and completely unreel feed hose 2
from base unit 5.
–Lock holding clamp 21 again.
Note: When painting only with the paint applicator 3 (without
extension 1), the feed hose 2 can be fastened in one of the
two exterior guide grooves 12 for more convenient working.
Mounting the Extension (see figures B1–B2)
– Screw the screw connection 10 of the extension into the
paint applicator 3.
–Fasten feed hose 2 in the straight guide grooves 12 of
paint applicator 3 and extension 1.
– Remove remote control 8 from paint applicator 3 and clip
it into holder 6 of extension 1.
Operation
Before any work on the machine itself, pull the mains
plug.
Preparing for Operation
Working close to the edge of open waters or on neigh-
bouring areas in the direct vicinity of open waters is not
permitted.
When purchasing paint, observe its environmental compati-
bility.
Preparing the Surface to be Painted
The surface to be painted must be clean, dry and free of
grease.
When working indoors, all non-covered surface can be soiled.
Therefore, thoroughly prepare the area around the surface to
be painted:
– Cover or mask off floors, furnishings, door and window
frames, etc.
– Also, sufficiently underlay the paint bucket and base unit
with covering-off material (foil, cardboard, etc.).
Preparing the Paint
– Prepare the paint according to the manufacturer’s instruc-
tions.
– Stir paint thoroughly and dilute as required.
When the painting result is not satisfactory or no paint comes
out: See “Correction of Malfunctions”, page 19.
Coupling the Base Unit and the Paint Bucket
(see figures C1 –C2)
– Set down base unit 5 level on the floor next to the opened
paint bucket.
– Pull the height-adjustable paint-bucket coupling 29 up-
ward to the stop.
– Hold the paint bucket handle upright and slide the hooks of
the paint-bucket coupling down to the edge of the paint
bucket.
Electric Paint Roller PPR 250
Article number
3 603 BA0 0..
Rated power input
W35
Paint delivery capacity
ml/min 400
Required time for application of
paint on 2 m
2
min 1
Length
– Paint applicator
– Paint applicator + extension
– Feed hose
cm
cm
m
40
120
5
Dimensions of paint roll
–Width
– Shank diameter
– Total roll diameter (without pile)
– Pile height
–Pile material
cm
mm
mm
mm
25
8
45 –50
11
Polyester
Weight according to
EPTA-Procedure 01/2003
kg 3.7
Protection class
–Base unit
–Trigger switch with
remote control
IP X4 *
IP X5 **
* Protection against water splash from all directions
** Protection against water jets from all directions
The values given are valid for a nominal voltage [U] of 230 V. For different
voltages and models for specific countries, these values can vary.
Henk Becker
Executive Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
OBJ_BUCH-1513-004.book Page 17 Tuesday, November 26, 2013 4:07 PM
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch PPR 250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch PPR 250 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 13,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info