594768
19
Zoom out
Zoom in
Previous page
1/247
Next page
English | 19
Bosch Power Tools 1 609 92A 0XB | (17.12.14)
Mounting VAC Accessories (see figure C)
The vacuum hose 21 is equipped with a clip system, with
which the VAC accessories (tool sleeve 20, elbow 22) can be
connected.
Mounting the Tool Sleeve
Mount the tool sleeve 20 onto the vacuum hose 21 until
both snap-fasteners 31 of the vacuum hose can be heard
to engage.
To disassemble, press both snap-fasteners 31 inward and
pull the components apart.
Mounting Nozzles and Tubes
–Mount the elbow 22 onto the vacuum hose 21 until both
snap-fasteners 31 of the vacuum hose can be heard to en-
gage.
Afterwards, mount the desired VAC accessory (floor noz-
zle, crevice nozzle, vacuum tube, etc.) firmly onto the el-
bow 22.
To disassemble, press both snap-fasteners 31 inward and
pull the components apart.
Inserting/Removing a Disposal Bag or Dust
Bag (Dry Vacuuming) (see figures D1 – D2)
For dry vacuuming, a disposal bag 23 or a dust bag (accesso-
ry) can be used. This makes the disposal of the dust easier.
Note: When using a paper filter bag, the automatic filter
cleaning (AFC) (see “Deactivating the AFC”, page 20) must,
and when using a fleece filter bag, should be shut off.
Inserting a Disposal Bag
Unlock the latches 11 and remove the vacuum lid 10.
Insert the disposal bag 23 into the container 1 with the fill-
ing opening toward the front.
Pull the filling opening over the connection flange into the
recess of the connection flange.
Make sure that the disposal bag 23 faces completely
against the interior sides of the container 1.
Fold the rest of the disposal bag 23 over the edge of the
container 1.
Reattach the vacuum lid 10 again and lock the latches 11.
Removing and Closing the Disposal Bag
Unlock the latches 11 and remove the vacuum lid 10.
Pull the full disposal bag 23 toward the rear off of the con-
nection flange.
Carefully remove the disposal bag 23 out of the vacuum
cleaner without damaging it.
When doing this, pay attention that the disposal bag does
not get caught or ripped open against the connection
flange or other sharp objects.
Pull the cover off of the adhesive strip, close the disposal
bag and tape it shut.
Afterwards, tie off the disposal bag 23 below the filling
opening with the pulled off cover of the adhesive strip.
Replacing/Inserting the Dust Bag (Accessory)
Unlock the latches 11 and remove the vacuum lid 10.
Pull off the full dust bag from the connection flange toward
the rear. Close the opening of the dust bag by folding down
the lid. Remove the closed dust bag from the vacuum
cleaner.
Work the new dust bag over the connection flange of the
vacuum cleaner. Make sure that the dust bag faces com-
pletely against the interior sides of the container 1 over its
full length.
Reattach the vacuum lid 10 again and lock the latches 11.
Inserting the Rubber Lip (Wet Vacuuming)
(see figure E)
Note: The requirements for the ingress degree (dust
category L) have only been proven for dry vacuuming.
Carefully pry the brush inserts 27 out of the floor nozzle 28
using a suitable tool.
Insert the rubber lips 26 into the floor nozzle 28.
Note: The structured side of the rubber lips must face out-
ward.
Attaching an L-Boxx (see figure F)
For transport of the vacuum cleaner and for place-saving stor-
age of VAC accessories and/or power tools, an L-Boxx can be
mounted on the vacuum cleaner lid.
Mount the L-Boxx onto the retainers 9.
Do not carry the vacuum cleaner by the carrying handle
of the mounted L-Boxx. The vacuum cleaner is too heavy
for the carrying handle of the L-Boxx. Danger of injury and
causing damage.
Operation
Starting Operation
Observe correct mains voltage! The voltage of the pow-
er source must agree with the voltage specified on the
nameplate of the vacuum cleaner. Equipment marked
with 230 V can also be operated with 220 V.
Please inform yourself about the valid regula-
tions/laws for your country concerning the handling of
materials that are hazardous to one’s health.
The vacuum cleaner is suitable for vacuuming and extracting
the following materials:
Dusts with an exposition limit value > 1 mg/m
3
The vacuum cleaner may generally not be used in rooms
where the danger of an explosion exists.
To save energy, only switch the vacuum cleaner on when us-
ing it.
To ensure optimal vacuuming performance, always complete-
ly unwind the vacuum hose 21 from the vacuum cleaner lid
10.
Dry Vacuuming
Vacuuming of deposited dusts
To switch the vacuum cleaner on, set the mode
selector switch 6 to the “vacuuming” symbol.
To switch the vacuum cleaner off, set the mode
selector switch 6 to the “Off” symbol.
OBJ_BUCH-1746-003.book Page 19 Wednesday, December 17, 2014 2:07 PM
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch GAS 35 L AFC Professional at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch GAS 35 L AFC Professional in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 28,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info