814761
12
Zoom out
Zoom in
Previous page
1/74
Next page
NM6063CB_IM 19.04.23
12
19 Lever for releasing the presser foot
20 Presser foot
21 Needle clamp screw
22 Mains connection socket
23 Foot pedal connection socket
24 Accessories compartment
25 Foot pedal
26 Power supply unit
27 Bobbin under-thread
28 Thread spool
29 Sewing needle
30 Threader
Warnings for the Use of the Appliance
Read the instructions!
Only use with “SW0601200-W02” power supply
unit! For the purpose of recharging the battery, only
use the detachable supply unit provided with this
appliance.
Do not use power supply with damaged plug! If
the pins of the plug part are damaged, the plug-in
power supply shall be scrapped.
WARNING:
Make sure that the switch (8) is in the OFF position.
Otherwise the sewing machine will start sewing
immediately.
Always unplug the foot pedal (25) from the appliance
when threading, changing needles or inserting the
bobbin.
Use only the accessories supplied or recommended in
these instructions. Use of non-recommended accesso-
ries may cause injury.
Handling Batteries
Do not charge batteries!
Do not disassemble batteries!
Do not short-circuit batteries!
Observe polarity (+ / −)!
Danger of explosion!
Do not expose batteries to intense heat, such as
sunshine, re or similar.
Batteries can leak battery acid. If the appliance will not
be used for a longer period of time, remove the batteries.
If a battery leaks, do not rub the liquid into the eyes or
mucous membranes. In case of contact, wash hands,
rinse eyes with clean water. Seek medical attention if any
discomfort persists.
Different battery types and new and used batteries must
not be used together.
Batteries are not to be disposed of together with do-
mestic wastes. Return used batteries to the responsible
collection points or to the dealer.
Notes for Use
You can operate the appliance either with batteries or with
the power supply unit supplied.
Inserting the Batteries
(Batteries not included in scope of delivery)
WARNING:
Make sure that the switch (8) is in the OFF position. Oth-
erwise the sewing machine will start sewing immediately.
1. Remove the battery compartment cover on the under-
side of the appliance.
2. Insert 4 AA / LR6 batteries into the battery compartment.
Pay attention to the correct polarity. You will nd a note
on this in the battery compartment. Do not use recharge-
able batteries.
3. Close the battery compartment again with the cover.
Connecting the Power Supply Unit
WARNING:
Make sure that the switch (8) is in the OFF position. Oth-
erwise the sewing machine will start sewing immediately.
1. Check that the mains voltage you want to use matches
that of the power supply unit.
2. Insert the mains plug into the mains connection socket
(22) on the back of the appliance.
3. Connect the appliance to a properly installed protective
contact socket.
Switching the Appliance On and Off
The appliance is switched off when the switch (8) is in
the OFF position.
There are two ways to switch on the appliance:
1) Set the switch to OFF and use the foot pedal (25).
2) Select a speed level L (Low) or H (High) with the
switch and the machine starts sewing directly.
LED Sewing Field Light
The LED sewing lamp is maintenance-free and does not
require replacement.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann NM 6063 CB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann NM 6063 CB in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info