552039
8
Zoom out
Zoom in
Previous page
1/16
Next page
8
10/2013
S
TARTUP
/
O
PERATION
Prior to first use
ATTENTION: After transport, the device should be left standing for 4 hours in order for the oil to
be collected in the compressor.
Nonobservance could cause damage to the compressor and hence
result in failure of the device. This would void your warranty claim.
- Clean the interior of the device including all accessory parts located inside.
Connect the device to the mains supply
IMPORTANT:
- The device must be earthed properly. For this purpose the plug of the mains cable has been fitted
with the intended lead.
- Contact an electrician if the plug does not fit in the wall socket.
- In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting
the device.
4. Separate the parts B, C, D
from the part A.
5. Place sliding rail (A) on the
inner door of the furniture door
up and down and mark the
position of boreholes. After
having drilled the holes, fix the
sliding rail with the included
screws.
6. Fix the cover (C) on sliding
rail (A) until clips into place.
7. Open the device and furniture
door about 90°. Insert the small
square (B) into guide (A). Push
the device and furniture door
together and mark the bore-
holes. Remove the square (B)
and drill holes with approx. Ø 2
mm till distance 8 mm from the
outer edge of the door. Place
the small square (B) on the
sliding rail again and fix it with
the included screws.
8. Should the lining up of the
furniture door be necessary,
use the clearance of slots.
Check if the door is arranged
vertical as well as horizontal,
so that a smooth opening and
closing of the door is ensured.
9. Fix the cover (D) on guide
(B) until clips into place.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann KSE 327 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann KSE 327 in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bomann KSE 327

Bomann KSE 327 User Manual - German - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info