651949

Bomann ES 184 CB Manual

53
Zoom out
Zoom in
Previous page
1/106
Next page
53
Instructions
Placement
• Place the appliance on a stable and level surface.
• Due to rising heat and vapours do not operate the appli-
ance under wall cabinets.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
Insert for the warming plate/cup shelf (13)
Place the insert in the notch at the top of the appliance.
Push Buttons (8/9)
These push buttons have the following functions when locked
in place or disengaged:
Switch Engaged Disengaged
8
(Pump)
(Standby)
9
(Steam) (Espresso)
Electric Connection
1. Ensure that your mains power corresponds with the speci-
cations of the appliance. The specications are printed on
the type label.
2. Check the push button settings! Push buttons (8/9) must
be disengaged.
3. Connect the mains cable to a properly installed and earthed
wall outlet.
On / Off
• Press the on / off button (12) briey to switch the appliance
on. The appliance starts heating up. The warming plate (13)
heats up.
• The Indicator lamp
lights up as soon as the necessary
brewing temperature is reached.
NOTE:
The indicator lamp turns on and off during operation.
This is normal and indicates that the temperature is
thermostat-controlled and maintained.
• In order to switch the appliance off, press and hold the on /
off button (12) for 4 seconds. Then disconnect the mains
plug from the socket.
European regulations on energy saving
NOTE:
The European Directive 2009/125/EC (Ecodesign Directive)
incorporates measurements for energy saving.
The following applies to coffee makers: The keep-warm
period is limited to max. 40 minutes after which the appliance
turns off automatically.
You benet from better safety and lower energy consumption.
Operation
WARNING: Important!
Before use, always check the button settings! The buttons
(8/9) must be in the off position, before connecting the appli-
ance to a properly installed earthed socket!
Attach / Detach Filter Holder
• Hold the handle at the left edge of the appliance to attach
the lter holder (see Fig. B on page 3). Insert the three
guide tabs in the group head recesses. With the handle pull
the lter holder to the right hand side to the middle of the
appliance. Ensure that the lter holder is well secured in
the group head.
• Pull the lter holder to the left to detach from the group
head.
WARNING: Danger of burns!
After brewing the metal parts of lter holder and lter
insert are hot.
Inserting the drip tray / drip tray grid
• Slide the drip tray for the residual water (6) into the com-
partment (5).
• Place the drip tray grid (7) onto the compartment as a
cover. The recessed edge must face the appliance hous-
ing.
First Use / Bleeding
CAUTION:
Bleed the appliance before rst use and after a longer period
of non-use. Do not use coffee grounds during this process!
1. Make sure that the drip tray (6) and the drip tray grid (7) are
inserted.
2. Fill the water tank with clean, fresh water to the MAX mark-
ing. Close the lid again.
3. Remove the lter holder (16) from the group head.
4. Press the on / off button (12) briey to switch the appliance
on. The status indicator lamp (11) lights up. The appliance
starts heating up. The warming plate (13) heats up.
5. Swivel out the steam nozzle (4). Ensure that the steam
pipe is properly attached.
6. Place a suitable container (heat-resistant / approx. 500 ml)
under the steam nozzle.
7. Turn the steam control knob (3) all the way towards “
”.
8. Press push button (8) to turn on the pump. Pumping starts.
9. Turn off the pump after water is evenly emitted from the
steam nozzle. Push button (8) is in position.
10. Close the steam control knob towards “ ”.
11. Empty the container and place it under the group head.
12. Press push button (8) to turn on the pump. The water ow
starts. Let all water from the water tank run through. Turn
off the pump to empty the container.
… 53 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bomann ES 184 CB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bomann ES 184 CB in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info