790584

Blaupunkt BPA 3022 M Manual

16
Zoom out
Zoom in
Previous page
1/72
Next page
Safety notes
The car sound system was manufactured according to the state of the art and
established safety guidelines. Even so, dangers may occur if you do not observe
the safety notes in these instructions. Read these instructions carefully and
completely before using the car sound system. Keep the instructions at a
location so that they are always accessible to all users. Always pass on the car
sound system to third parties together with these instructions. In addition,
observe the instructions of the devices used in conjunction with this car sound
system.
General safety notes
Observe the following note to protect yourself against injuries:
Do not modify or open the device.
Use as directed
This sound system is intended for installation and operation in a vehicle with 12
V vehicle system voltage. Observe the output limits of the device. Repairs and
installation, if necessary, should be performed by a specialist.
Installation instructions
You may only install the car sound system yourself if you are experienced in
installing car sound systems and are very familiar with the electrical system of
the vehicle. For this purpose, observe the wiring diagram in these instructions.
Installing the device must not obstruct or block the function of any airbags,
other safety devices or controls.
Declaration of conformity
The Blaupunkt Competence Center Car Multimedia - Evo Sales GmbH declares
that the device complies with the basic requirements and the other relevant
regulations of the directive 2014/53/EU. The declaration of conformity can be
found on the Internet under www.blaupunkt.com.
Cleaning notes
Solvents, cleaning and scouring agents as well as dashboard spray and plastics
care product may contain ingredients that will damage the surface of the car
sound system. Use only a dry or slightly moistened cloth for cleaning the car
sound system.
Disposal notes
Do not dispose of your old unit in the household trash!
Use the return and collection systems available to dis-pose of the old
device, the remote control and exhausted batteries.
Scope of delivery
The scope of delivery includes:
Main unit BPA 3022 M
Remote control
ISO connectors
Installation screws
Operating manual
ATTENTIONS OF INSTALLATION
1. Please read the instruction manual carefully before installing the unit.
2. Make sure to connect other wires before power on the unit.
3. To avoid short circuit. Please make sure all the exposed wires are insulated.
4. Please x all the wires after installation.
5. Please make connection to the player accordingly to this instruction manual.
Wrong connection may cause damage to the unit.
6. This player only t for 12V DC device.
INSTALL THE UNIT
REMOVE THE UNIT
1. Remove the unit
2. Take out the outer trim frame.
HDMI attention:
Please use good quality HDMI cable.
The overall length (front and rear) should not exceed 12 feet.
WIRING CONNECTION
1. This player can only be used by + 12V DC.
2. Do not connect the battery terminal until the player is fully well installed.
3. Please make sure to connect the yellow wire to the positive of the battery (+).
4. When change the fuse please make sure that the specications are same.
5. Using good quality speakers with 4 - 8 ohm can achieve the best eect of the
unit.
OPERATION
LOCATION OF KEYS
1. STREFA 1 2. 1 3. STREFA 2
4. 2 5. BT 6. 3 RPT
7. 8. 4 RDM 9.
10. 5 DIR- 11. DIS 12. 6 DIR+
13. LCD 14. GNIAZDO AUX 15. GNIAZDO SŁUCHAWKOWE
16. GNIAZDO HDMI 17. RESET 18. POKRĘTŁO
19. PORT USB 20. SRC/MENU
BASIC OPERATION
Turn on/o the unit and Mute function
Press /MUTE knob to turn on the unit. When the unit is on. Shortly press this
knob for mute on/o. Press and hold this button to turn o the unit.
Audio and setting menu adjustment
Press and hold SRC/MENU button into the menu as below:
BAS->TRE->BAL->EQ(o/pop/rock/clas)->LOUD(on/o)->CLK HH->CLK
MM->IR(on/o) ->CT(indep/sync)->BEEP(on/o)->P_VOL(13)->DX(LOC)->STE-
REO(MONO)
In each item rotate the VOL knob to set them.
IR (ON/OFF):
IR ON: The unit can be switched on by IR remote control.
The system is in high power consumption status.
IR OFF: The unit can not be switched on by IR remote control.
The system is in low power consumption status.
CT (INDEP/SYNC):
CT INDEP: The clock works independently.
CT SYNC: The clock will be synchronized to the received RDS station’s time.
Note: When the clock was set in the menu, The CT is set to INDEP mode
automatically.
BEEP (ON/OFF): Turn on/o the beep sound when buttons are pressed.
P-VOL: Setting the power on volume. If the volume at switch-o is lower than
the P-VOL, the unit will set the volume to the value of the switch-o volume
when it is switched on.
If the volume at shutdown is greater than the P-VOL, the volume will be restored
to the
P-VOL value when the unit is switched on.
Bluetooth speaker search
Press and hold BT button shows “SEARCH..”. Seconds later shows the Bluetooth
device name. Rotate VOL knob to show next one. When the desired Bluetooth
speaker name was shown on LCD. Press VOL knob to pair. If the pairing is
succeed, it shows BOX ON.
Important note: Despite numerous tests with various Bluetooth devices,
compatibility with all Bluetooth devices available on the market cannot be
guaranteed.
Bluetooth speaker signal transmit operation
Shortly press BT button to stop/transmit the signal to the Bluetooth speaker. It
shows BOX OFF/ON.
Note: Although Blaupunkt checks the compatibility of dierent Bluetooth speakers
with care, a awless function with all models on the market cannot be guaranteed.
Zone 1 and Zone 2 operation
Shortly press Zone 1 (or ZONE 2) button to unable/enable Zone 1 (or ZONE 2)
volume.
Hold Zone 1 (or ZONE 2) button to mute Zone 1 (or ZONE 2) sound. Hold it
again to mute o.
Information or Clock priority
Shortly press DIS button to change the clock priority or information priority.
Note: In FM band, when received a RDS station shortly press DIS button to show
the STATION NAME/CLOCK/FREQUENCY.
Clock setting
In CLK HH/CLK MM item of the menu. Rotate VOL knob to set the hour/minute.
Head phone operation
There is a 3.5 mm head phone jack in the front panel. It is following the zone 1’s
operation.
RADIO OPERATION
Receive a radio station
Press SRC/MENU button to select FM1->FM2->MW mode. Shortly press /
button to receive the desired radio station. Press and hold / button for
manual tuning the frequency.
Manually store station & recall preset station
Receiving a desired station. Press and hold one of the preset buttons (1 - 6) for 2
seconds. The current station is stored into the number button. Shortly press the
preset button (1 - 6) to directly listen the station that saved in the corresponding
preset button.
DAB OPERATION
Press SRC/MENU button switch to DAB1 or DAB2 source.
Selecting station
Press / button to select up/down station.
Manually store station and recall preset station
When received a desired station. Press and hold 1 - 6 button for 2 seconds to
store this station to corresponding number. Shortly press the preset button (1 -
6) to directly listen the station that saved in the corresponding preset button.
USB OPERATION
When an USB driver was inserted to the unit, the unit will play the MP3/WMA le
automatically. If an USB drive is already inserted in the unit, keep pressing
SRC/MENU button shortly until the USB mode display appears.
Select le
Press / button to skip to next/previous le. Hold / button to
fast forward or fast reverse.
Play/Pause
Press 1 button to pause/playing the le.
Repeat function
Press 3 RPT button to select RPT mode: RPT ONE/RPT FOLD/RPT ALL(default)
RPT ONE: Repeat the same le.
RPT FOLD: Repeat all les of the folder.
RPT ALL: Repeat all les.
RANDOM
Press 4 RDM button to choose RDM on/o.
RDM on: Playing all les in random order.
RDM o: Turn o the random function.
Directory+/- function
Press DIR+/DIR- button to select next/previous folder to play.
Search song
Press and hold button shows NUM 0000. Rotating VOL (or directly enter
number) to select the numbers then press VOL to play. Please note the 7/8/9/0
as: BT = 7, = 8, = 9, DIS = 0.
AUX IN 1/2 OPERATION
AUX IN 1 for front panel 3.5 mm jack. AUX IN 2 for RCA in back of the unit.
Pressing SRC/MENU button to switch to AUX IN1 (2) mode when Connecting
the audio signal to the unit .
BLUETOOTH OPERATION
Pairing
On mobile phone, select the Bluetooth item searching the Bluetooth device.
“BLAUPUNKT” should appear in the list, select “BLAUPUNKT” and then input
password “0000” if it needs a password. When successful paired, the BT mark will
be displayed on the display.
Bluetooth Audio
Press SRC/MENU button to switch to BT MUSIC mode. It will play a song of your
mobile phone automatically. Press key to pause/play the song.
Press / button to select next/previous song.
HDMI OPERATION
The front HDMI port is pass through to the rear HDMI port. The HDMI playback is
therefore not aected.
V-IN and V-OUT RCA connector
In the back of the unit the V-IN connector is pass through to the V-OUT
connector.
REMOTE CONTROL
When IR is set to ON in the setting menu.
OFF : The unit can be switched ON and OFF.
VOL+: Volume up
VOL- : Volume down
1 : Zone 1 MUTE ON/OFF
2 : Zone 2 MUTE ON/OFF
Other operation please reference the description above
GENARAL
Power Supply Requirements : DC 12 Volts, Negative Ground
Chassis Dimensions : 129 (W) x 112 (D) x 65 (H)
Tone Controls
- Bass (at 100 Hz) : ±10 dB
- Treble (at 10 kHz) : ±10 dB
Maximum Output Power : 4 x 40 watts
Current Drain : 10 Ampere (max.)
RADIO FM AM
Frequency Coverage 87.5 to 108 MHz 522 to 1620 KHz
IF 10.7 MHz 450 KHz
Sensitivity 4 µV (S/N = 30 dB) 36 dBµV (S/N = 20 dB)
Stereo Separation >25 dB /
TROUBLE SHOOTING
EN
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt BPA 3022 M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt BPA 3022 M in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 14.13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info