585414
12
Zoom out
Zoom in
Previous page
1/28
Next page
12
6. REPAIRS AND MAINTENANCE
Figure 2
“Direction of blade
rotation”
Make sure that the machine is fully disconnected and all moving
parts are secured before performing any maintenance/repair
work on the machine. In the event of any malfunctioning, switch
the machine off before trouble-shooting.
6.1 Regular maintenance
The following tasks belong to ordinary maintenance works:
Clean the machine from eventual residual wood, chips or dirt.
Lubricate all moving parts.
Grease all pivoting parts of the carriage
6.2 Cleaning after use
Remove wood chips and saw dust produced and left on the machine
du
ring work. Clean the carraige assembly removing all wood rests.
6.3 Replacing the saw blade
Safety note ! Wear safety gloves - pinched hands danger.
Before replacing the blade make sure to disconnect the machine
from power (unplug the electric motor).
Following instructions apply for safe and proper blade replacement:
Disconnect power off the machine (unplug power cord or stop the
motor of the tractor) and wait for the blade to come to a complete stop.
Tip the upper blade hood over by releasing and removing the 4
hex-screws with hex-nuts.
Release and undo the xation bolt on the blade clamping ange.
using a spanner and hold the blade using another spanner (wrench ats
SW41)
to secure the blade ange on the motor side as you undo the nut
Remove the clamping fl ange.
Pull the old blade off the shaft (make sure to wear tear-resistant
gloves. DANGER!) and take it out through the top.
Fit the new blade on the shaft. Note direction of rotation. All tools must al-
ways work against the feed direction that is revolutions must occur towards
the operator’s station (see g. 2).
Mount the locking fl ange back on the blade shaft minding the right posi-
tion of the feather-key in the fl ange.
Tighten the shaft nut to hold the fl ange securely in place! ATTENTION
to assemble the new blace follow the sequence: blade, external clamping
ange, washer, fi xation bolt.
Refi t the blade hood in the original position duly set and clamped.
log carriage
saw blade
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BGU 701 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BGU 701 in the language / languages: English as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info