534707
38
Zoom out
Zoom in
Previous page
1/73
Next page
BFB-3000 Set Up and Operations Manual
Document No: D100253 38
Recommended maximum extrusion temperatures for materials:
Material
Extrusion temperature (°C)
ABS
260
PLA
195
Note: Extruders share power, therefore an extruder will heat up quicker if it is the only
extruder with a high target temperature.
6.9.3 Purge the extruder
Ensure filaments are loaded into the extruders, as defined in the section Load the
filament, page 31.
Make sure the springs on the extruder pressure bearings are fully compressed.
Compression needs to be adjusted from this setting.
Proceed by purging one extruder at a time:
Heat the extruder to the maximum temperature defined below, depending on the
material in the extruder:
Material
Extrusion temperature (°C)
ABS
260
PLA
195
Once target temperature has been achieved, turn the RPM up to 15.
If the motor on the extruder stalls (you will hear a ‘clicking’ sound) release the
pressure on the filament by unscrewing the pressure bearing bolt with the hex driver
until extruder motor stops stalling (motor will run without clicking). After this point,
unscrew the bolt another half turn to ensure the motor does not stall during
operation.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BFB 3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BFB 3000 in the language / languages: English as an attachment in your email.

The manual is 8,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info