568800

Beurer IPL 9000 plus Manual

36
Zoom out
Zoom in
Previous page
1/124
Next page
36
WARNING
Do not treat the same area of skin more than once per hair removal session!
Treating an area of skin more than once during a single hair removal session can increase the proba-
bility of side effects.
Try to avoid overlapping pulses.
Note
The pulses from the beurer SalonPro System should be applied in rows – beginning at one end of
each row, continuing to the other end. This technique allows better monitoring of the areas of skin
that have already been treated and helps you to avoid treating the same area more than once or tre-
ating overlapping areas of skin. The light area of the beurer SalonPro System is designed in such a
way that it leaves a temporary impression on the treated area of skin. These visible impressions can
be used for precise placement of the next pulse. Additionally, a lengthways marking is located on the
left- and right-hand side of the cartridge that helps you to determine precisely where the light area is
at any time.
10. Remove the applicator from the skin and place it on the next part of the treatment area. When repo-
sitioning the applicator, make sure not to leave any gaps or overlap the treated skin. The device
recharges itself immediately and is ready for the next pulse within three seconds (the indicator lamp
on the applicator continuously illuminates green once again). Repeat the process until the entire area
of skin has been treated.
After treatment using the beurer SalonPro System
• Once the hair removal session using the beurer SalonPro System is finished, switch off the device by
flipping the power switch off.
• Unplug the mains cable from the mains socket.
• After each hair removal session, it is recommended that you clean your beurer SalonPro System,
paying particular attention to the light area (see Chapter 9.1 "Cleaning the beurer SalonPro System").
• After cleaning, it is recommended that you store your beurer SalonPro System in its original box and
keep away from water.
8.2 Facial treatment
WARNING
Do not use the beurer SalonPro System on your face at an energy level higher than 3.
Do not use the beurer SalonPro System on your face above the cheekbones or on the eyes, eyeb-
rows or eyelashes, as this could result in severe damage to the eyes.
Do not use the beurer SalonPro System on mucous membranes in the nose or throat area.
The skin on your face is very sensitive and requires special care. Observe all warning and safety notes
in these instructions for use to prevent adverse consequences. We recommend that you first perform a
treatment on your body and get to know the device before performing facial treatment.
All areas of the face below the cheekbones, such as the upper lip, cheeks, jaw, chin and neck can be
treated using the beurer SalonPro System.
Note
You have the option of ordering a special attachment for treatments to the face (item number 576.07)
from Beurer Customer Services. The attachment for treatments to the face can be attached to the
light unit and reduces the size of the treatment area to enable more precise application.
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beurer IPL 9000 plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beurer IPL 9000 plus in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 7,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info