568807
13
Zoom out
Zoom in
Previous page
1/68
Next page
13
Connect the other end of the hose [7] to the hose
connector [4] on the nebuliser by lightly turning it.
Mains connection
Connect the unit only to the mains voltage listed on
the type plate.
Insert the mains cable plug [3] into a suitable socket.
Push the plug completely into the mains socket.
Note
Ensure that there is a socket near to where the unit
will stand.
Lay the mains cable in such a way that no one can
trip over it.
To disconnect the nebuliser from the mains after use,
first switch off the device and then remove the plug
from the socket.
6. Operation
Caution
For hygiene reasons, the atomiser [8] and the ac-
cessories must be cleaned after each treatment and
disinfected after the last treatment of the day.
If several different medicines are to be inhaled in suc-
cession during therapeutic use, the atomiser [8] must
be rinsed under warm tap water after each use. For
information about this, see “Cleaning and disinfec-
tion” on page 14.
Follow the instructions for changing the filter con-
tained in these instructions.
Before each use, check that the hose connections
on the nebuliser [4] and the atomiser [8] are tight.
Before use, check that the device is functioning cor-
rectly. To do this, switch on the nebuliser (including
the connected atomiser, but without any medication)
for a short time. If the atomiser [8] expels air, the
device is functioning correctly.
1. Filling the atomiser
Open the lid of the atomiser [8].
Fill with an isotonic saline solution
or pour the medication directly into
the atomiser [8]. Do not overfill! The
maximum recommended fill level is
8 ml !
Use medication only on the advice of
a physician, and check the appropri-
ate inhalation duration and quantity
for your needs.
If the required volume of medication is less than 2 ml,
top up this quantity to at least 4 ml using an isotonic
saline solution. Viscous medicines may also require
dilution. Always follow the instructions of your doctor.
2. Closing the atomiser
Close the lid of the atomiser [8].
3. Connecting the accessories to the atomiser
Connect the required accessory part (mouthpiece [11],
nosepiece [12], adult mask [13] or child mask [14]) to
the atomiser [8].
Before commencing treatment, pull the atomiser up-
wards out of its holder [6].
Start the nebuliser using the on/off switch [2].
A flow of spray from the atomiser indicates that the
device is functioning properly.
4. Treatment
Inhale the nebulised medicine deeply.
Note
During treatment, hold the atomiser straight (vertical),
otherwise the atomisation does not work and correct
function cannot be guaranteed.
Important
Essential oils, cough medicines, solutions designed
for gargling, and drops for application to the skin or
for use in steam baths are wholly unsuitable for inha-
lation using a nebuliser. These substances are often
highly viscous and can impair the correct function of
the device and hence affect the effectiveness of its
application in the long term.
In the case of oversensitivity of the bronchial system,
medicines containing essential oils can sometimes
cause acute bronchiospasm (a sudden, cramp-like
tightening of the bronchi accompanied by breathless-
ness). Always ask your doctor or pharmacist for advice!
5. End of inhalation
If the spray is only output sporadically or if the noise
changes during inhalation, you can end the treatment.
After treatment, turn off the nebuliser at the switch
[2] and disconnect it from the mains.
After use, replace the atomiser [8] in its holder [6].
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beurer IH 25-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beurer IH 25-1 in the language / languages: English, German, French, Italian, Polish, Turkish, Spanish as an attachment in your email.

The manual is 5,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beurer IH 25-1

Beurer IH 25-1 User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info