568807

Beurer IH 25-1 Manual

14
Zoom out
Zoom in
Previous page
1/68
Next page
14
6. Clean the device
For information about this, see “Cleaning and disinfec-
tion” on page 14.
7. Changing the filter
Check the filter after every 10th use. If the filter is very
contaminated or blocked, replace the used filter. If the
filter has become wet, it must also be replaced with
a new one.
Caution
•
Do not try to clean and re-use the used filter!
•
Only use original filters supplied by the manufacturer.
Otherwise, your nebuliser may become damaged or
effective therapy can no longer be guaranteed.
•
Never operate the device without a filter.
To replace the filter, proceed as follows:
Caution
•
First switch off the unit and unplug it.
•
Allow the unit to cool down.
1. Turn the filter cap [5] an-
ti-clockwise and remove
it towards the front.
Note
If the filter remains in the unit when the cap is removed,
remove the filter from the unit using tweezers or similar.
2. Re-insert the filter cap [5] with a new filter. To do
this, insert the cap and turn clockwise until it is felt
to engage.
3. Check that the filter cap is firmly in place.
8. Cleaning and disinfection
Atomiser and accessories
Warning
Observe the following hygiene instructions in order to
avoid any health risks.
•
The atomiser [8] and accessories are intended for
multiple use. Please note that cleaning requirements
differ according to the different application areas.
Notes:
•
The atomiser and accessories must not be me-
chanically cleaned with brushes or similar as this
can cause irreparable damage and the success of
the treatment can no longer be guaranteed.
•
For additional requirements regarding the necessary
hygienic preparations (hand washing, handling of
medicines or inhalation solutions) in high-risk groups
(e.g. cystic fibrosis patients), contact your doctor.
•
Ensure that all parts are properly dried following all
cleaning and disinfection. Residual moisture or water
droplets can result in an increased risk of bacterial
growth.
Preparation
•
Directly following each treatment, all parts of the
atomiser [8] and any accessories used must be
cleaned of medicine residues and contamination.
•
To do this, dismantle the atomiser [8] into its indi-
vidual parts.
•
Remove the mouthpiece [11] from the atomiser.
•
Dismantle the atomiser by turning
the atomiser insert [9] anticlockwise
against the medication container [10]
and pull upwards.
•
The nebuliser is later reassembled in
the reverse order.
Cleaning
Important
Before you clean the unit, always switch it off, unplug
it and let it cool off.
The atomiser and the used accessories such as
mouthpiece, mask, etc. must be washed with hot wa-
ter after each use.
Carefully dry all components using a soft cloth. Once
all components are fully dry, reassemble the atomiser
and place the components in a dry, sealed container
or carry out disinfection.
When cleaning, ensure that all residues are removed.
Never use any substances that may be poisonous
when in contact with the skin or mucous membranes,
or when swallowed or inhaled.
Clean the device using a damp cloth, to which you can
apply a little detergent if necessary.
Do not use abrasive detergents and never immerse the
unit in water.
Important
•
Ensure that no water penetrates inside the unit!
•
Do not put the device or accessories in a dishwasher.
•
Do not touch the unit with wet hands while it is plugged
in; do not allow any water to be sprayed onto the unit.
The unit must be operated only when it is completely
dry.
•
Do not spray any liquids into the ventilation slots. Any
liquid that penetrates into the unit can damage the
electrical parts or other components of the nebuliser
and impair the function of the device.
Condensation, care of the hose
Depending on the environmental conditions, con-
densation may collect in the hose. To prevent against
1
2
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beurer IH 25-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beurer IH 25-1 in the language / languages: English, German, French, Italian, Polish, Turkish, Spanish as an attachment in your email.

The manual is 5,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beurer IH 25-1

Beurer IH 25-1 User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info