810575
36
Zoom out
Zoom in
Previous page
1/66
Next page
10 | Air+ installation and operation EN Operating manual Heidi Back
36
10.5 Installing the DC plug
1) Guide the power cable with plug through the rear
panel and fasten it as per the picture.
10.6 Electrical connection of the controls
Power supply Damper motor Firebox temperature
1) Make sure that all the components are correctly con-
nected.
2) Plug the mains cable plug into the electrical point.
Test the air control system and set the minimum and
maximum motor position - calibration process.
3) Wait approximately three minutes after the plug has
been plugged in and then check whether the air con-
trol system (rotary knob) has fully opened and closed
by itself again after these three minutes have expired.
4) The air control system (rotary knob) should be com-
pletely closed again after the calibration process.
5) The air control system (rotary knob) did not com-
pletely open and close during these three minutes.
Therefore check the following:
Plug correctly connected to the mains.
Air control system is functioning. Any LED display lights
are flashing.
All components are correctly connected: check whether
all connectors are correctly connected.
Is the temperature scale in the combustion chamber
above the ambient temperature? If the stove is warm
due to a previous firing process or if the stove is just
warming up, this will be detected by the air control sys-
tem. Therefore the calibration process will be prevented
and the air control system will switch straight to com-
bustion phase 1.
Check the rotary knob. It should be capable of being
turned against a slight resistance. Otherwise the rotary
knob and all connected components must be checked.
Despite the automatic air control system the position of
the damper doors can be manually adjusted.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Austroflamm Heidi Back 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Austroflamm Heidi Back 2.0 in the language / languages: English as an attachment in your email.

The manual is 7.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Austroflamm Heidi Back 2.0

Austroflamm Heidi Back 2.0 User Manual - German - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info