580229
26
Zoom out
Zoom in
Previous page
1/48
Next page
2-10
To install the battery unscrew the cap of the battery housing and
insert the battery following the polarity arrows marked on the
housing. Put the cap in place.
The IR-450 illuminator has a control panel with two buttons. To
switch the IR illuminator on/off press “+” and “-” buttons simultane-
ously. When the IR illuminator is switched on you can see the green
LED lit on the back side of IR450. By pushing the buttons “+” and
“-” you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To
change the beam width slightly turn the IR lens.
You may need adjust the focus-
ing of the IR beam to change
the field of coverage.
Do it by slightly rotating the IR
lens. The windage and eleva-
tion screws help adjust the di-
rection of the IR beam from the
IR450 in order to focus on the
scene observed in the view-
finder of your NVD. Use the
included Allen wrench to rotate
the adjusting screws until the
IR beam is centered. Please
remember the adjustments
should be performed under
night light conditions only.
You can change the position of the IR control panel to meet your
your needs. The wrench that is included in the set, is used to
loosen the nut located on the body of the IR. Rotate the IR to the
desired position. Tighten the nut with the wrench to secure the
new position.
NUT
CONTROL PANEL
WRENCH
TO TIGHTEN
NUT
TO LOOSEN NUT
FIGURE 2-9. CHANGING OF
CONTROL PANEL POSITION
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATN PS28 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATN PS28 in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info